Tubes of Repair PVC Glue for Inflatable Boat

Easy to use and sealed up the hole in my SUP perfectly!!! Saved my summer!

Really great deal for you get. Tons of patches and glue. Works great.

Have used this to repair 3 holes. Seems to hold well and stop the leaks. There were no application instructions but I just followed some others online and it seemed to work well.

Used this product to seal two punctures on my son inflatable kayak. Process was easy and the patches and adhesive of high quality. Let it cure for 24 hours. Patches held. Great product!

This item is OK. Nice orange container. A few different PVC patches and 2 tubes of MEK glue with instructions. Kind of pricey for what it is.

A mouse nibbled a small hole in my SPB over the winter! This repair kit did the trick. Holds air now and with 2 glue tubes, the patch kit might last until needed again.

I accidentally stabbed a hole into my inflatable paddle board when adjusting my fins ( silly mistake I know) but this patched it right up! I followed the directions carefully ( I’ve seen people say this doesn’t work, follow the directions and it will) and it patched it perfectly. Within the next few days I took my paddle board out and I had a very successful and enjoyable 4 hour trip on the water; the patch continued and continues to hold up. I will say I put some gorilla waterproof sealing tape over the patch as an extra precaution but I think I would be okay without it. Definitely recommend this if you need to seal some type of inflatable.

Instructions skip the step of sanding to prep the surface. This absolutely will not work without that step. I didn’t even bother trying to use their “Gule”. (See photo)

J'ai acheté cette colle pour reparer mon zodiac afin de ne plus acheter de la bi composant. Efficace, resistante, prise rapide.

Repair some leaks in my inflatable boat Works great

Rien a dire

This kit worked perfectly on two holes that were both roughly 12mm in diameter in my inflatable boat. Cleaning the area to be glued with acetone (not supplied) is 100% essential, I also cleaned the patches supplied with the kit beforehand too. Apply a covering of the glue to both the area around the hole and the supplied patch, then wait 5 minutes before applying a second coating to each once more. 5 minutes after the second coat I then applied the patch over the hole, rubbing the two together with a blunt wooden straight edge. I then left the glue to cure for 48hrs before inflating the RIB (HD Quicksilver 3.5m) and it has held beautiful under load on rough seas. I recommend this product 👌 but acetone must be used pre-gluing in my opinion. I hope this helps 🙏

Produit simple d utilisation et pratique avec sont rangement étanche