45° Downrigger Mount for Lund Sport Track, G3 & Ranger Boats, Universal 6" x 6" Aluminum Track Bracket for Brocraft, Cannon, Scotty & Big Jon Downriggers

This bracket fits my 2017 Ranger VS1780 perfectly. I didn’t have to add any shims and it is a tight fit. Since I have a classic (very old) down rigger, only two holes line up with the bracket. I am impressed with the strength of the bracket.

This bracket fits my Lund 2008 1825 Explorer Sport. I have it paired up with my Cannon Uni-Troll 10 downriggers and the pair work excellent together! I do recommend this bracket.

Purchased for use on my Lund Tyee. I use a Cannon Uni-troll 10 manual downrigger with a 10lb ball on this mounting bracket. The bracket is sturdy and secure. In order to get the bracket nice and secure, I use a crescent wrench to add a little more torque when tightening the knobs otherwise the knobs can loosen up while you are fishing. This product works well for someone who does not want to drill holes in their boat.

These things are solid. I don’t think they’ll have any trouble holding my manual Canon downriggers. I was disappointed that there were no directions for setup, but it wasn’t hard to figure out. I had to move the supports to fit the narrow gunwhales on my Lund Impact. The bolts for the support knobs were a bit loose in the threads. I also had to drill out the mounting holes slightly to fit the holes in the mounting plate. Once I had everything where it needed to be, I put Loctite on the bolts. Things seem solid now. I put some Gorilla tape on the back to hopefully keep it from scratching my track.

Used this mount to install a Scotty Downrigger setup on my Lund Impact boat. The mount fit perfectly on the Lund rail system and the required mounting holes for the Scotty components matched up also. Result was a very nice final assembly. Will definitely buy again for my next downrigger / boat install. 04/13/2023 - After using these mounts for awhile the leveling legs came loose due to the boat's vibration. To stop this from happening I applied thread locker to the threaded legs of the levelers before they were retightened into position. This eliminated them from loosening again! The mounts can still be removed from the boat if needed however.

It's perfect fit for my lund 1625 with the sport track waiting on arrival of my downrigger but the mount itself looks amazing looks sturdy

fits my 2000 Lund Angler track, no drilling required. I have used it once to hold a cannon 10 downrigger, works fine so far. just need to move a couple of the screws around so that the black knobs rest on the side of the boat and can be tighten down

Needed to add some electrical tape to the mounting plate to level the unit.

Very robust piece of hardware. Very impressed with its design and sturdiness. Fits my Yamaha G3 with a slight inboard tilt that takes the pressure off the grove mount. The only thing that could be better is it that it is difficult to “untoggle” the bolts to remove. There is a slight grove in the end of the bolt that acts like a landmark for the toggle, it would be helpful if a screwdriver could fit in there to turn the toggle out. I’m going to try a little thread locker on the toggle bolt so tje knob will bind a little at the end to turn the toggle. If that fails I’ll cut a grove in the end for a screwdriver.

I never write reviews but feel like a I have to in this case as this product quality for the price is unbelievable, buy with no worries

Works great and well made. Fits perfectly the rail of the boat.

Everything about this product is exactly what I needed.

shipping time very good and product is very well made. fits perfectly so very happy with purchase.