Cerakote Premium Microfiber Applicator (Pack of 3) - Quality Microfiber Material - Washable and Reusable - Perfect for Car Coating Application

Small but perfect for applying exterior dressings to a bumper or cladding. Rigid structure lets you get those edges perfectly.

They were good. I would buy them again.

This is an amazing product! It performed just as well as some of the more expensive brands.

Disclaimer: I received this product at no cost via the Amazon Vine program; however I will not let that influence my review of the product. I do professional auto detailing and so I have a lot of experience with many detailing products. These applicators works great to apply LSP or ceramic coatings. If you use them for ceramic coatings you will only get 2 uses out of each of them (one for each side) becasue the coating will harden on the applicator even if you clean them immediately after use. This is common for all ceramic coating applicators so it's not a knock against this particular product. If you're using anything besides a ceramic coating, you can certainly clean and reuse these applicators except that I wouldn't dry them in a clothes dryer becasue the heat will mess up the plastic layer inside and deform the applicator. The applicators are a decent size, hold their shape well enough, and are pretty decent at not soaking up too much coating/product.

I have tried a few different applicators but I like this one the best. Just the right size.

GREAT PRODUCT.

they work well, very soft

Does as advertised.

perfect for ceramic coating absolutely anything. have the two coloured sides makes it easier to determine which side was used for what product as well.

Great for doing the dash! Put product on the down side and squeeze into where the glass meets the dash and gets the dashed shined without getting any product on the windshield. Would always get marks on the windshield when using only a cloth. These little guys are perfect for that and squeezing into all the hard to reach with a cloth areas.

When compared to foam blocks with the throw away suede cloths, I find this uses more product. I used about 50ml where usually it would be about25-30ml. I will say though, that this type follows contours easier, needs reloading less often and helps me finish quicker. Time is money, so I would use these on customers cars.