Question 1

I will be using this transducer with my home theater setup, Witch speaker outputs would be best to use, is it better to use say Center channel output

Accepted Answer

Please use SUBWOOFER OUTPUT / LFE = signal output / RCA jack - not speaker output. In some cases we can recommend to use the power of zone 2 speaker outputs (if enough power and not used for zone 2 speakers / another room). The best performance can be achieved with HIGH CUT / LOW PASS filter 40-88 Hz and strong amplifier especially strong at low frequencies.CENTER mostly has no low bass frequencies.

Question 2

Hi, could I run 2 of these in series from a Reckhorn 2.1 3 amplifier?

Accepted Answer

I am driving one of these from a 70W amp output and usually do not turn the volume past 30% or it is too much. If you are driving two of these in series (8 ohm) from a single channel of your amp (I think your amp is 40W per channel and can drive 8 ohms), then you may be on the low-power side. If your using both outputs (80-90W) then your probably fine. These shakers seem pretty efficient.

Question 3

I'd like to hookup 8 of these, will the buttkicker bka1000-n amp work? or is there another suggestion to appropriately power 8, maybe even 10?

Accepted Answer

You can connect as many BS-200 as you want with a combination of parallel + series wiring. But please make sure that the final impedance of all connected BS-200 is not below the minimum requested impedance of the amp speaker output. The amp delivers its highest power on its lowest allowed impedance, example: A 4 ohm capable amp with 4 x BS-200 in series & parallel = 4 ohms. If the bka-1000 really offers 1000 watts it can drive 8-10 x BS-200. But if you turn to max. the amp can be overloaded. We suggest an amp which has good protection circuits for overload, overheat, low impedance etc.. Further: The amp must not get down below 30 Hz like many lower cost amps because you need high power in the very low bass frequency range.

Question 4

Can I hook this up to my receiver without a separate amplifier? How do I turn the speaker wire from the transducer into a rca input?

Accepted Answer

if your receiver has a speaker level output you can hook the plus and minus to the bass shaker, if your receiver only has an rca out you will need a separate amp for the bass shaker. Most receivers only have an rca out to be used with a powered subwoofer

ASIN	B00AMH17GC
Antenna Location	home theater
Audio Driver Type	Dynamic Driver
Audio Output Mode	Surround
Brand	Reckhorn
Compatible Devices	Home Theater, Television
Compatible with Vehicle Type	Car
Connectivity Protocol	Aux, RCA, Bluetooth, Wi-Fi
Connectivity Technology	Auxiliary , Bluetooth, RCA , Wi-Fi
Control Method	Voice
Customer Reviews	4.6 out of 5 stars 387 Reviews
Is Waterproof	FALSE
Item Weight	1.2 kg
Manufacturer	HENITAR
Maximum Range	393.7 inches
Model Name	Bs 200
Model Number	BS-200
Mounting Type	Flush Mount
Number of Audio Channels	5.1
Number of Items	1
Power Source	Corded Electric
Speaker Maximum Output Power	200 watts
Speaker Size	15.8 centimeters
Speaker Type	Subwoofer
Warranty Type	Limited
Wireless Technology	Bluetooth, Wi-Fi
Woofer Diameter	16.5 inches

Reckhorn Bassshaker Body Sound Converter for Home Cinema, Playseats + Therapy

Details

Details

Description

Specifications

Common Questions