Metal Case with Cooling Fan for Orange Pi 5 Pro/Max/Ultra(N515)

Solid build, included extra hardware in case you drop / lose something, easy assembly, read the directions! bare board sitting on my desk - 60C at idle, up to 70C at load after installation in case with heatsink and fan - 38C at idle, 45C at load.

It looks sturdy. The instruction is not clear to make the fan work well.

case is okay as advertised

Itd be a great product if the fan was a lil bigger and actually had the right fan connector for these board however you can connect to any other pin or the out 5v and get away with it. Dont worry about the extra fan in the pic it fits fine I just plugged an extra fan I had

Lo único es el soporte, que es muy pobre, para lo demas está bien...

Fan connector does not match the mating connector on Orange Pi 5 Max board. This enclosure is recommended by Amazon when purchased. Now I do see Orange Pi 5 Max zinc alloy case on Amazon but can't tell if the fan connector matches the one on Max board. Otherwise everything else works and looks just fine.

Justo a la media de la Orangepi5 max y trae los tornillos completos

Sturdy construction and built to be disassembled down the road if need be. I used this with the 5 max and the ports line up fine. If you have antennas that are mountable/detachable, they can mount just fine in the long vent slots, which gives you options. Less than great: - instructions are limited to a sheet that has a link to a three minute blurry video. It was enough but took a few views. - instruction sheet with the link referenced the orange pi 3, which had me worried for a moment. - recessed power button is probably for the best, but the SD card port is recessed far enough that I may need to disassemble the case or use needle nose pliers to get it out. - clearance for the nvme drive is adequate but the chips on my drive are almost touching the bottom of the case. Depending on the drive you use, this may make it impossible to wall mount. Not important to me, but may be to some. - heat sinks included seem to be for the 5 pro. The 5 max has a bigger processor and its raised, flat surface is not completely covered by the heat sink. - The sink for the memory is a touch too big but no big deal there. - The video shows them putting the small heat sink on what I think is the Ethernet chip. Again, a little small but okay. - The video doesn't show them putting a sink on the Wi-Fi/Bluetooth chip and one is not included, so I didn't. Sounds like a lot of negatives but for me the end result was fine. We'll see about cooling given the heat sinks but really that's my only concern.

As advertised .. Arrived quicker than expected

Fits the orange pi 5 pro perfectly, easy to assemble, fan works as expected.