Recoil 20-Feet 9-Conductor Speaker Cable 16AWG Pure OFC Easy Peel Jacket

product came as advertised and on time. bough this product for a wired remote control on my home made crane. so far so good cable is flexible enough to move around as you load a trailer. will see what the winter brings, i think the outer sleeve will harden in the cold.

This speaker cable is great! I’ve installed car audio amps before, and running 4 speaker wire cables plus remote wire from the rear of the head unit to an amp ( usually at the rear or trunk of a car) would always be a hassle. This cable solves that problem. The outer jacket is easy to cut, which might cause it to cut in to the outer jacket if it gets caught on a sharp edge. But it makes installing a 4 channel amp much easier. The remote wire is also included, along with 4 pairs of color coded wires, making it fast to install. The wires are also color coded and should match up most aftermarket stereo harnesses, making it easier to determine which wire to connect to the harness easier, and also troubleshooting in the future easier, since you’ll know exactly what wire is going to the left from speaker for example, especially if you don’t label each wire with a tag or write on the wire like i used to do. The cable I ordered was 20’, which was more than enough for me to go from the rear of my head unit, snake it through to the passenger side, all the way back to my 4 channel amp up behind the seats of my super-cab truck. I ran it through braided sleeving along with RCA’s to give me a more modern style “wire snake” for better protection than zip ties, and used heat shrink tubing at the ends to secure the braided sleeve and prevent frayed ends. You can also use Tessa tape, just avoid electrical tape as it leaves a lot of residue.

The convenience of this is very real 💯. The quality is great. It is color-coded, matching the colors on the metra radio install harness. ### Just solder the matching colors for the speakers (positive wires: purple, green, white, and gray. negative wires: same as positives' colors but with the black line), and the blue wire for the amp turn on to the matching colors on the metra radio install harness. ### Then solder the red, yellow, and black colors (along with any other wiring you may have for additional accessories) from the metra radio install harness to the correlating colors on your aftermarket radio wires. ### Then run your rca's from your aftermarket amp to your aftermarket radio. Just like that, your amp is connected to your radio and is powering all of your speakers. ## No need to run new speaker wiring, especially to your doors. ## Oxygen-free copper is of great quality and is flexible. ## All wires are contained and organized in a wiring loom. ## Also, keep in mind that you're getting 9 wires that are 20 feet each. I absolutely recommend this and have no regrets.

Love these cables, makes a 4 speaker wire run a breeze. Only caveat, if you have really tight spaces, it may be a challenge to get this to fit. Wire quality is top notch and 16 awg is plenty for mid/high speakers.

Great quality and easy to work with. It would be cool if the wires were twisted in the jacket but then it would also make the bundle slightly larger.