Tenacious Flexible 3D Printer Resin, Easy Grey, 1kg

Quite possibly the worst resin I've ever used, so bad that I ended up pouring the remaining 85% of it in to a large vat & curing it all before disposing of responsibly. I was quite excited to give this resin a go & expected good things in the hope it'd be a cheaper replacement for the Phrozen RPG resin i currently use. Lots of vigorous shaking to make sure it was well mixed & in to the vat which raised its temperature to what is recommended. Spent a couple of hours calibrating the resin to my printer (Elegoo Saturn 4 16k Ultra) & then ran a set of prints through it which were duplicates to ones I currently hold in stock (Phrozen RPG). Washed & cured the finished prints which had a glossy finish to them, almost translucent at the thinner parts, the detail was ok but nothing compared to what you get using Phrozen RPG resin. There's hardly any "flex" in the cured resin but probably just about enough to prevent easy snapping points of limbs. When I cleaned out the vat I found thick congealed resin as I poured it back in to the bottle, had almost runny jelly consistency to it along with some very thin cured strips. A very odd experience with this resin throughout , I wont be wasting my valuable time or money with it again. I gave it two stars as it did print to an ok-ish standard but certainly not of a good enough standard to sell via Etsy etc... I've added four images, two are using Tenacious & the other two are printed using Phrozen RPG.

Sirayatech Tenacious is only in Clear and Obsidian Black. The other color, Easy Grey (and Navy Grey i suspect), is actually just Grey, the "Easy" part in color name stands for mixture, which is different then in other "tenacious" resins. So when you buy Easy Grey you buy "ABS-Like" resin and not a "Tough Resin" or "Flexible Resin" as you might suspect by name. While it's a great "ABS-like" resin it is not what I expected and I blame confusing naming scheme.

Horrible, smelly and hard to clean. Get water washable. You won't go back.

je l'utilise pour renforcer pour les pièces de jeu la siraya navy grey, à hauteur de 10% . Mélange bien connu et très fiable, une base pour les amateurs de figurines de jeu

Espectacularrrrrr, Las miniaturas ya no se rompen y definición perfecta.

Très bonne qualité mais très très dur à paramètres beaucoup de teste avant malheureusement il faudrait avoir une bibliothèque des paramètres pour des différent objets ou une liste avec déjà des bon paramètres aussi non c'est galère même sur le net les tuto pas facile à trouver mais ça reste une très bonne qualité et ne sans pas trop

もっとゴムに近いのかと期待していたが、全然硬い。

This resin is xlnt and prints beautifully with the correct settings. One thing to note is this resin needs to be used at least 26Deg Celsius for best results. At first I tried it and room temperature was 22 deg and I got bad cracks and layer separation. Then I bought a resin printer heater and set it to 27 deg c and let the resin in the vat and the printer warm up for 30 minutes then printed and then everything was perfect with no setting changed beside the temperature. Strong with a little bit of flex. Odor is I would say medium compared to others, It's not odorless but also not strong as well. So I would say medium-low odor compared to other resins so all in all very good. Sirayas stock settings work well on the MONO M7.