Monitor Desk Mount Ultra Wide Full Motion Swivel Long Arm with Gas Spring for 22''-35''Monitors from 6.6 to 26.4lbs Height Adjustable Monitor Stand G70-W

Bought it over Black Friday weekend. I really don't get too excited over monitor arms or leave a review unless somewhat negative. I am very impressed with the build and mechanics of this arm. Two things it did for me are getting the right height of my 32 inch monitor instead of using the stock stand. The stock stand was wider and difficult to find a monitor stand to fit which leads to the second item, clearing a bigger amount of space under the monitor that I couldn't use before, such as speakers and other things. Overall pretty clear cut instructions. There are a few videos on youtube that are close to this one, but just take your time installing and you'll do fine. You might want to offset the base if you want the monitor to fit further back. All depends on your setup. I used the grommet and drilled a one inch hole through my desk. The arm and base is solid as a rock. Its a pretty heavy solid wood desk and I believe I could pick up the desk using the arm. All the parts were perfect and heavy duty. The only negative thing is I'm sure someone in the family is going to spot this and want one, so I'll be installing another one pretty soon.

Great mount, built very solid. It is able to hold my acer 27" monitors no problem. I bought it to get it as close to the wall as possible and it works well. Would recommend 2 mounts instead of dual. (The stickers are easily removable)

These are very nice monitor arms. Great value, very sturdy, decent instructions with all included parts. They are heavy and look nice. I bought two and have both installed on my desk. Assembly is not hard, but there is more to it than I expected, and you need to pay attention to the instructions. Of course when you have the monitor attached you also have the extra weight to contend with, so make sure you have enough room to assemble and install. I was putting two on the same desk and wanted both screens to butt together in the center, so I needed to move the bases several times further apart to allow them to both monitors to fit properly together. The mount arms have plenty of adjustments, and once you set the joint tensions properly for the weight of your monitor (tight enough to hold in place, loose enough so it can move) , it is easy to move and adjust the arm with monitor and keep the new position. I am very happy with these monitor arm mounts.

I bought two right out of the gate after a TON of research. I wanted the ability to use the clamping option or the desk mount option. My desk is made of two old doors from 1913 and so I need them to be mounted rather than clamped due to its positioning. These I suspect will not disappoint me. I love the pneumatic arms, the stands hold my two 32" curved displays without issue. One thing I would like to see, have the hdmi/dp ports where the two USB ports are in the back of the stand. To me it makes more sense. I mean why string the HDMI/DP cable thru the cable covers - I have two 6' cables and wish I had bought 2 10' cables. The ability to hide the cords is lovely, but I'd rather plug the monitor into the stand and the stand into the pc. Anyway, buying this mount could not be a bad idea. I'm happy I spent the money, the desktop footprint is small, and the setup efficient. I work from home so having a clean workflow is good. Fewer cables even better. I'll post photos once my desk is reorganized... but I think I will love this. Do the research, but for me, this is the only brand I will buy - it is EXCELLENT quality. Sturdy, and clean, and WHITE. It goes well in my workspace.

I haven't been inspired to write many reviews lately, but was oddly thrilled with this purchase. I bought the 6.6-19.8 lbs version of this monitor arm. When I ran an IT department at a hospital, it frankly would have easily run about $150 or more for similar quality. Although the instructions are a little messy, it didn't take long to figure out how to adjust the arm as desired. One tip that isn't mentioned in the instruction manual is to loosen the tension screws on both rotational joints before inserting the bottom arm into the base and/or the top arm into the bottom arm, else you can't insert them fully. I bought this for a desk in my bedroom so that I could swing the monitor from one end of the desk to the other, depending on whether I was working on my PC or watching movies in bed. It has great reach, pivots and swings into position easily and maintains position well. As long as the gas cylinder is of decent quality and holds up from a lot repositioning, I'll be very happy with this purchase. One bonus with this model is cable management - it has built-in covers/guides for running cables and there are also two USB ports which more or less act as a mounting point for USB extension cables to help with cable management. (12/28 edit: Added photo)

I now have two of these arms. The original was ordered in 2018 and I’ve been very satisfied with it. So when I added a second 32” monitor to my desk, I simply chose “Buy it again”. But the second arm is built completely differently. And the knuckle where the monitor and arm meet is very flimsy now. It’s still a good arm, but it doesn’t live up to the earlier version.

Clear instructions. Holds my 32 inch acer monitor well and allows my computer to be dual purpose. I change the position of my monitor constantly and it tilts, moves, and adjusts with ease. For $27 it was a serious upgrade to my workspace. Once clamped to the desk the desk is more likely to move than the base of this monitor arm.

very high quality, these are made of metal with minimal plastic parts, just on the cable way covers. solid and well constructed. easy to install and look great.

شاشتي G7 من سامسونج مقاس 27 وتعتبر شاشه ثقيله والحامل ممتاز تحمل حجمها وثابت 👍🏼

facile da montare e da installare crea più spazio sulla scrivania

Will easily hold up a G8 Neo on my desk

MOVEMENT I have tried out a few monitor arms before and this one was by far the smoothest I have used. The swivel action is so easy and there is zero stiffness in moving the monitor around. The tilting of the screen angle is the only stiff part but I almost never tilt the screen so this was not a problem for me at all. It's very sturdy. AESTHETICS I purchased the white version, and the finish is better than could ask for, it matches my EIZO monitor perfectly - matt metal finish and looks very neat on the desk. While I would've preferred an all white arm, the grey / black accents actually blend in well with the overall look. The stickers on the arm could be easily removed leaving no residue too. SIZE The size of this monitor arm may have been a bit too big for my 23' monitor, when folded all the way back, you can see the joint exposed which may not be the best look but I don't mind it personally, if you have a bigger monitor it will definitely hide it. The length of the arm is also longer than one I has previously, so I don't have my cables threaded through the entire thing as they were not long enough (you can't see them anyway :) ) ASSEMBLY Piece of cake - took me 15 mins.

Ich bin mit dieser Monitorhalterung sehr zufrieden, sie tut genau das, was sie soll. Die Montage war dank der Anleitung unkompliziert und mein Monitor wird jetzt sicher und stabil in der gewünschten Position gehalten. Die Einstellungsmöglichkeiten zum Neigen und Schwenken sind sehr gut und haben die Ergonomie an meinem Arbeitsplatz deutlich verbessert. Endlich habe ich wieder mehr Platz auf dem Schreibtisch.