Threshold Ramps for Doorways Self-Adhesive Rubber Ramps for Door Threshold Rubber Door Threshold Ramp for Wheelchair Stroller Scooter Reducer Ramp (Black, 3” Wide x 3.3' Long)

Excellent for 3/4 to 1 inch thresholds or.

Just added an enclosed porch to our house. Forgot that the new threshold might be a problem with my rolling walker. This was perfect! Now I've ordered one for the other side of the door and for two more doors. I hope the adhesive lasts for years to come. So pleased with this problem solving purchase!

Product: 3" Wide x 6.6" Long. I purchased for a vacuum robot. I have two thresholds, each is about 1/2" high (1st photo), so I doubled up and layered the product (photo 2). It works great for the robot to get up the "ramp". My RoboRock S8 could get up before I added the ramp, but he had to work very hard and make several tries. With the new ramp, no issues! I am going to glue the top layer shown in photo 2 to the bottom layer, but not attach it to the floor. This ramp will only be used when the robot vacuums. I am going to buy this product again as I have a 2nd door to do and its threshold is exactly the same. While I did not use it the adhesive that would glue it to the floor is very sticky (great!). The rubber seems to be good and sturdy and high quality (great!). The reason for 4 stars is because several others have commented the product is not straight (it curves) when you unfurl it from the box; it comes coiled up inside a 10" x 10" square box. In photo 3 I have temporarily laid and aligned the product to the wall on the left hand side (blue line) and you can see the gap on the right hand side (red arrows). I don't think this curl will be a problem if you use the adhesive, but as I said above, in my case I am not attaching the product to the floor and will only be placed over the existing threshold when the robot vacuum is working. I believe this lack of straightness is due to the coiling of the product inside the box due to the "slant" to create the ramp. I also believe if this product was packaged differently this lack of straightness would be resolved. I will try to use a heat gun to warm the product before I glue my two layers together and see if that helps. Luckily, the doorway is only about 2 feet wide, so there is only a small gap at this point from the curl. The piece in photo 3 is 29" long, so it is wider than my doorway, but shows the lack of straightness. The box the product came in is 10" x 10" so the product is tightly wound to fit in the box.

Easy to cut & install. Worked perfectly for the bathroom entry way. Wheelchair goes over it effortlessly.

Needed it to make it easier for a transfer chair. Works great.

Very easy to install and was exactly what was needed.

Perfect fix for my mom's new motorized wheelchair going into the garage in our newer home. It was so quick to measure and cut to size. I'm very happy with the purchase and overall value.

The self-adhesive ramp arrived in good order. It was coiled up in the box, so I straightened it as much as possible and put it near a heat source overnight. I cut it to fit and stuck it to the floor. It allows my disabled spouse to get from one room to the other easily with his rolling walker. The two ends still curl up slightly, and I step on them occasionally, but the center stays where it belongs and it works adequately.

Absolutely bang on and fulfill my expectations. Easy for me to commute via wheelchair.

I needed my EUFY robot vacuum to clean my bathroom as well. This allowed it to do so. Super sticky and does exactly what it should.

Bought after Mum broke her hip and needed to use a Walker. Perfect solution for the entry into the bathroom from the bedroom. Wheels move effortlessly across this non slip rubber.

Works well in my house especially for my husband who is in a wheelchair

ثابته وتؤدي الغرض