Nilight 2PCS 16AWG 10 Feet Wiring Harness Extension Kit, Extended Plug and Play 2-pin Socket DT Connector Wire Cord for Offroad LED Light Bar Work Light Led Pod Driving Fog Boat Light, 2 Year Warranty

Good quality. Used these on my dirt bike to wire up a rear light.

I had a set of 3” Nilight pod lights with wiring harness to install as rear lights on my Ranger 570 SP. The Nilight harness with relay was great! But it was too short to keep the relay and fuse in the front compartment on the pulse panel. These were the perfect solution! The extensions are plugged in under the tunnel to each of the individual light leads from the Nilight harness. And there was just enough length to run behind the seat back, up the driver side roll bar, and to each light. (Had about 1’ too much for passenger side light, so should be fine for full-size Ranger too.) Now have a weatherproof, factory quality installation with no splices or solder joints. The only mods I had to make for the entire install (not related to these extension cables) were: 1) Cutting the ring lugs off and adding waterproof heat shrink butt splices to Polaris pulse plug, and 2) Buying a factory-style Carling L1 illuminated switch to replace the round switch provided. (This is a direct plug and play too since the Nilight switch wiring has 1/4” faston connectors.)

This was perfect for me. I had two lights bars in my rear bumper and needed to extend the harness to my fuse block. Great value

parfait

Worked great. Plugged in with no problem.