Homewerks 7140-110-G3 Bathroom Fan Ceiling Mount Exhaust Ventilation, Silent 2.0 Sones, 110 CFM, White

Excellent exhaust fan, very quiet and not too difficult to install. It’s exhaust port is located on one side so this can complicate the installation and depending on how your joists and existing piping are run it can make you need to cut a new hole in you ceiling so it lines up with your existing exhaust run.

This went in easily. I expected to need a 4-to-3 inch adapter, but nope. Hooked right up. We can barely tell that it is on , but it does a great job of removing bad air.

Easiest thing in the world to install... Assuming the mounts are on the correct side. I had to get a little creative and drill 2 holes on the opposite side since there was no way to attach the exhaust the other way (wish it had mounts on both sides!). But that aside, had it wired up in about a minute, had it screwed to the beam and running in 2 more. Tested it by letting my water run full heat in the shower and closed the door for about 5 minutes.. this little thing does its job without hesitation. A little louder than I was expecting but it's also in a very small bathroom, also it does specifically state the noise level in the description but I have no idea how those terms calculate over into the real world so I'm not docking a star for that. The cover is a little flimsy but at least the springs attach to metal instead of plastic(very common point of failure in another brand). For less $$ than the competition and very decent ability to do its job.. great little fan, highly recommend.

Most ventilation fans of this type are so overpriced that it's embarrassing just to comparison shop. If you pay a hundred bucks or more for a bathroom fan, it'd better sprinkle pixie dust through the room, or something. This fan works well and is surprisingly quiet, although the bearings are oddly loud. Still quiet overall, but with more mechanical noise than I expected and less fan (air turbulence) sound. Fine, though. Draft is good. The instructions are so-so, but maybe a third of the time you get decent instructions with anything, so I guess that's just how it is. Don't do wiring yourself if you're not confident about it. This fan wants to be mounted in a particular way that's convenient to new construction and probably half of 'old construction' (ie, adding it to an old bathroom ceiling or replacing an old fan), and it really doesn't want to be turned sideways so the grille is on a wall, or so on. It has push-in electrical connectors that are more trouble than they're worth; if there's any problem and you need to disconnect the fan again, you'll have to cut the wires, which is not helpful. My fan leaked a lot of air around the removable duct connector, so I taped the edges. Otherwise, attaching the duct was no problem. The fan's mounting instructions recommend removing the fan from the housing, in some cases, but doublecheck your install because you may not be able to get at the screws to reinstall the fan after you mount the housing. That won't amuse you. For the money, this is a great modest little fan. Better than average. If you're installing it yourself and have DIY experience, it won't cause you a lot of trouble. For new construction, it should be a snap.

Most of the problem I see with a lot of these fans are that they seem quite large hanging from the ceiling. if the bathroom is large these large fans don't look that bad. But if your bathroom is small then you have to have something that has a much lower profile like this fan. It works great is very very quiet and does the job. Now just for info purposes the quieter the fan the less it pulls from the room just keep that in mind if you want to use this fan in a large bathroom. You might need something more powerful which means noisier, unfortunately you can't have one without the other.

We had to replace an old vent in our restroom. It was a very messy job, no fault or relevance to this product of course. But after getting through our own hurdles, this snapped in quite easily. Looks beautiful, quiet, and powerful. We use to have a lot of dust but since replacing our old vent with this one, the presence of dust has dramatically decreased. Well made and so far no functionality issues.

This fan was ordered to replace a failing old model. It fit right into the previous cutout and is nice and quiet

Bad a$$ looking light with exhaust fan. 3 months in sounds like Magnum Pi landing. If you're a fan of helicopters buy this fan. Quiet to start but they went super cheap on bearings. I do not recommend buying this chopper. Can't imagine it actually working more than a year seeing/hearing how its degrading.

Super quiet. Moves good about of air

Beau look, silencieuse et efficace. Facile d’installation.

Wow, pour le prix et la qualité. C'est vraiment parfait. Ce genre d'accessoire n'est habituellement pas très esthétique. Mais, celui-ci est vraiment très sobre et se fond dans le décor.

Made to last and maintain easily. Easy install and powerfull. Made in USA :)

Very good product was hard to find a fan with the same configuration I neeed. Took longer to take old one out than to put new one in.