Siraya Tech Sculpt 3D Printer Resin High Temperature Resistance Resolution Resistance for DLP/LCD Printers Like Moonray 3D Printing Rapid Resin for Engineering Jewelry and Industrial (Clear, 1kg)

Sculpt ultra is one of the most amazing resins I've used and really shows the trickle down of material science to consumer level printers. It barely absorbs any water or solvents and is incredibly rigid. It's very ceramic like in many ways, probably because it IS filled with ceramic particles. It's a bit difficult to print, bed needs to be leveled just right and more importantly, because the resin is so opaque, the z-height needs to be very small to not have bed adhesion issues. I had a ton of issues until I realized that was my problem. Whenever I level my bed, I then set the zero a couple steps down and everything is good. The prints come out very smooth and because it's so brittle, the supports come off the cleanest of any resin I've tried. It also means you can't drop your prints as it will shatter like glass. Highly recommend for specialized use cases where you need high chemical, wear and heat resistance.

I was warned this is tricky to print with, but apart from ensuring the temperature is kept to a minimum, it seems no more difficult than anything else I’ve used. I had one initial failure, mostly because of my rush to place supports, but have since printed several items with no issues. Good detail and exceptional dimensional accuracy. I cannot fathom why, but I also use less of this resin for the same models printed with another product. Weird, but good!

Résine épaisse, super pour faire des moules pour injecter de la résine, résistance à la chaleur au top. Une super marque.

La compre para hacer moldes de joyería de goma/caucho ya que la resina resiste la temperatura de vulcanizado de lo moldes. La resina suele imprimir con éxito la mayoría de las veces y reproduce los detalles con fiabilidad. No obstante tiene algunas pegas, como un olor algo desagradable, necesidad de usar con cierta temperatura y resulta bastante frágil, pero el mayor inconveniente es que se pega a los moldes de silicona vulcanizable, lo que hace que sea poco útil para hacer moldes. Si se compra para otros usos puede ser una opción recomendable.

I use this resin for printing lens mounts for IP camera modules. The modules can get quite hot, so I went looking for a good HT resin. I had used other resins from Siraya Tech before, and was pleased with the results, so decided to give Sculpt a try. For this application, it has turned out to be a near-perfect solution. It prints clean without much shrinkage. There's a bit of warp on the first few layers, but the layers that count are plane parallel to one another. The only drawback is that it is a thick resin, so you will find that the solids in the resin will settle out over time. Shake/mix well and empty your vat after use and you should be golden. In terms of printability, I haven't had any failures, yet, and I'm fairly relaxed when it comes to controlling things like room temperature. I print with Siraya Tech's recommended settings for my printer, stir my vat between prints and the results are always good.