10Pairs Amass XT60H Upgraded Version XT60 Bullet Connectors with Covers Sheath Male Female Power Plug for Lipo Battery RC Planes Cars

The connectors are exactly what I expected to be purchasing. The male and female plugs fit together very snugly which is desired for this type of connector. Of the three or so I've used so far all of the wire-shrouds snap into place well and are quite hard to remove once they've been snapped in place, so like shrink tubing don't forget to pass the wire through the cover before soldering. I'm using 12AWG silicone-jacketed wire with these connectors and the exposed end which gets soldered to the connector nests neatly into the connector for soldering, in addition the holes in the grey wire covers are a hair bit bigger than the OD of 12AWG silicone wire, I assume they would be a tight fit if using 10AWG but would still allow them to pass through. Until I've used them for a while and can see how well they hold up to repeated use, my only gripe with these would be the little bit of flashing left over on the plugs from the injection molding process. Definitely not a deal breaker as this can be easily taken care of with an exacto knife. Should I need more in the future I'll definitely be ordering these specific connectors again.

Connectors feel good and have a tight fit

good quality, perfect for what I wanted

As far as XT60 connectors go, these might just be the best. They’re a great value over the pre-wired XT60 connectors, just take your time to learn to solder them. The quality is fantastic, as long as you don’t melt the connector while you’re soldering them, the fit will be perfect. Functionally, the connection is solid, as long as you take your time and learn to do it right, and even if you don’t, they’re cheap and plentiful enough to make a few mistakes.

These connectors were perfect for my project of putting new connectors on all of my drone and rc car batteries so that I can use them without adaptation with my iSDT chargers. The caps to cover the soldering area are a nice touch for a cleaner look and not needing to use a ton of shrink wrap! I still use about 3/8" of shrink wrap near the ends just for double protection in case of a potential short.