100 Pcs High Temperature Non-Insulated Female Spade Connectors - 12-10 Gauge Quick Disconnect .250 Tab - Wire Splice Connectors for Strong Crimps in Electrical Wire Terminals - Made in USA

These actually seem to be much nicer than the ones I can buy at any store locally. I would recommend them earnestly. Good tight connection. Just a little harder to crimp, but very good connection. They work very well and are a great value for the money.

Pictures show the old burned original equipment and the new one functioning. I needed these for a dryer repair, the original female end must have not been connected correctly or had a defect, in short created heat and failed. From a person who has used a lot of these types of connectors, these are very nice, they fit tight, have a noticeable heavier weight VS harbor frightening type cheap ones. It so happened that I needed to replace the cord on my welder, got to use them again.

Good price good product

Sherlock IMHO the king of terminals for copper quality Nd strength and amazing holding crimp force. Super clean crimps and multiple uses. This doubles down as .250" f2 battery terminals for 10ah batteries. This can be used to make diy ato fuses as the kegs of each fuse fit perfectly They a work for speaker applications

excellent product

This is not the same as what you would buy in the stores. These are very heavy duty. The material is easily twice as thick as the other types you would be use to. The nickel in them keeps them looking nice in all types of conditions. Toss some heat shrink tube over them after you crimp them on and you have the best setup you could ever ask for. Now the first time you try to push them on to a connector it will be very tight. In hard to get to places I find it best to grab a male and female connector with pliers and push it on once or twice to make the install easier in the tight place. It still helps to push them on while grabbing them with pliers.after they have been pushed on a couple times the get much better while still holding very tight connection. The connection is much tighter and better than from those cheaper ones you get in the stores.

You get top quality , great fit and funcion

Worked fine for repairing the cord on my Hobart 190 welder