250ml Sublimation Coating for All Hard Surface, Solution Spray for Mugs,Metal,Wood,Ceramic,Tumblers,Glasswith High Gloss Finish, Waterproof and Super Adhesion

I put it on dollar tree mugs it works and a board for my wreath worked great

I followed the instructions that came with it and also another similar product.When applied you can see the brush streaks, even after curing in the oven.There is also very little catalyst included. I used half of it but there was still a lot of the base that still needed the catalyst.I then used a small spray bottle thinking it would even out and eliminate the streaks. The spray eliminated the streaks but bubbly spots replaced the streaks.You can see both results in the pictures. One with streaks, the other with bubble spots.It's a bust for me. Don't buy this type of product it is a waste of money and time.FYI, technically this product worked when I tested it. It just isn't practical to use it unless if you've figured out how to make it applicable evenly.

This product had NO WARNINGS about plastic and even came with a plastic cup. After adding the catalyst it ATE THROUGH THE CUP and completely ruined my antique table. 🙈 I did get a chance to use a tiny bit and it was spotty at best.

Product was spilled inside never open . Started a return but was in the middle of a move and list track of it. So I’m now stuck with a box with product spilled on the inside.

This product did not work, it peels the paint and does not sublimate

It does not go on smoth makes your bank look very bad from the start. I didn't even try to sublimate on it because it already looked so horrible.

I attempted to use this product to make coasters on finished tiles. I followed their directions and even let this substrate set for 2 days longer than recommended. When I did try to sublimate onto it, it all transferred onto the paper leaving very little of the ink behind. Behind. I attempted a couple different processes even letting it cool before removing the paper which resulted in the paper being semi-permanently affixed to the tiles. I ran them under the water to remove the paper which I was sort of successful at but it pulled the substrate and the ink off with it.I have not attempted to use this product on a porous material, it may give you better results that way.Additional thing that I really disliked was there is no cleanup instructions that came with this product. I foolishly tried to use a airbrush, and then when I went to clean it up realized that it does not dissolve with acetone or alcohol.

No instructions ,fumes are horrible, had window open fans on etc. cleanup was horrible as well ended up throwing everything away . Do not recommend at all and will never use again . Wish I could give it less than one star