Stainless steel business card blanks for laser engraving

Just right. Not to thin or thick. And it engraves well.

This are a little thicker then the normal one but engrave bette

Great quality. Nice and sturdy and looks great after engraving.

These are a good thickness, made of aluminum, engrave a nice bright white with no residue, and don't curl too much when engraving.

I bought these to mess around with using my laser. I have a Jtech 24W diode laser installed on an old CNC machine in my cabinet shop. These cards are really 0.4 mm thick. That seems a nice thickness that won't bend badly. I've seen other cards that are listed as 0.2mm thick and I think those would seem very thin. They engrave fine. Since I'm just doing this for myself I've not tried to do it as fast as possible. I found a setting that worked and stuck with it. I've been engraving them at 120 Inches Per Minutes at 50% power. I'm sure I could go faster is I wanted to, but that is fine. They are messy after they have been engraved. They need cleaned to get the burnt paint dust off them. I just threw them in the sink and washed them all off. I don't think any harsh chemicals are needed. I've attached two photos, one with a card after engraving and one with the card cleaned up a little. I use these to give to my best clients. Repeat customers and other people I work with a lot. That way they can easily find my card. The only reason I knocked off a star was the way they were delivered. They are only wrapped in some weak plastic. My cards all came undone and were thrown everywhere in the box. I'm sure I lost some through the gaps in the cardboard box. Only a few were scratched up so bad I couldn't use them. Since they are heavy and have sharp edges they should be packaged together better.

Great! Used for car show plaques, engraved beautifully.

Perfect for laser engraving

My clients love these as my business cards. I’ve used thinner material ones and these are no comparison.