Question 1

How long  Should l live before sanding

Accepted Answer

This putty should be applied as a very very thin layer. It is only designed to cover the very minor imperfections and is not a filler. If applied as prescribed it will harden quickly depending on temperature. In a cold environment use a heat gun carefully to accelerate the hardening. If applied too thickly it may not harden throughout and may just form a skin. Work quickly when applying as it may start to harden prematurely and form lumps on the spreader that will drag across the surface. Clean the putty from the spreader regularly using white spirit to avoid a hard build up which will drag the putty.

Cover with one very thin coat and allow to set fully then sand, if there are still imperfections repeat, don't try to cover in on thick coat. What looks like a smooth finish will quickly be revealed to be the opposite, if imperfections exist, when the paint is applied and dries.

I did notice that it may react with some undercoat paints as the paint is applied and bubble slightly. If it does just smooth it down before the paint fully dries and give it another coat of the same undercoat paint to stabilise it. There does not appear to be any later long-term degradation after doing this. You may want to check before use by applying on a test area of thin putty and the undercoat that you intend to use. Note the bubbling did occur on a very low-temperature day and an acceptable panel temperature was being maintained with careful application of a heat gun so this may have been a factor. This was a situation requiring urgency and painting is best done outside on a warm day or in a warm environment.

Question 2

Will this work on alloy wheels not as filler but after alloy filler to smooth out imperfections before or after primung?

Accepted Answer

Yes, probably.  It dries very quickly and very hard.  You will need to rub it down with wet-and-dry paper 240 grit or similar.  Anything finer takes for ever.  It takes primer OK.

Question 3

Instructions of use

Accepted Answer

After you have used normal filler and rubbed down and used a primer filler just use a small amount to cover minor imperfection

Question 4

putty not staying on when sanding once dry. i using  car sanding paper. . any advise

Accepted Answer

Prep the the spot on the panel you are working on with a sanding disc with a cors paper to take the 2 top layers of top coat not as for a bear metal then then mix the filler putty up so it soft then spred it into the spot then get a hot air gun or a stand heater then  the after get a lighter sand paper just to take the top coate off then use wet and dry sand paper with a little washing up liquid and water then you be ok bud that's what I did and that's it and painted then done bud that's all I can say

ASIN	B005BP5I4M
Best Sellers Rank	487 in Automotive ( See Top 100 in Automotive ) 3 in Gloss Seals for Car Paints 27 in Sponges, Cloths & Brushes
Brand	Holts
Customer Reviews	4.3 4.3 out of 5 stars (1,508)
Date First Available	8 July 2011
Delivery information	We cannot deliver certain products outside mainland UK ( Details ). We will only be able to confirm if this product can be delivered to your chosen address when you enter your delivery address at checkout.
Guaranteed software updates until	unknown
Item Weight	100 g
Item model number	LOYCAT13
Manufacturer	HOLTS
Manufacturer part number	LOYCAT13
Model	LOYCAT13
Product Dimensions	10 x 10 x 10 cm; 100 g

Holts Cataloy Car Body Filler, Knifing Putty To Fill Scratches & Stone Chips, Durable & Easy To Use Car Filler, Ideal For All Exterior Bodywork With A Perfectly Smooth Finish, Applicator Included 100g

Description

Specifications

Common Questions