84-01 Jeep Cherokee XJ 4.0L 2.5" Aluminized Exhaust Kit Jones Muffler Rear Exit

This product was an easy fit for my jeep. Sound is good though louder than stock. The stainless-steel body of the muffler is a huge upgrade from OEM.

It’s an oem replacement that’s slightly louder, easily changed by swapping the muffler for a magnaflow etc.Came with extra length on all the pipes so you have to cut a few inches off here and there, but also super easy with a sawzall and a torch/Diablo blade.The exhaust hangers are goofy though😂Fit my 2000 xj sport.Also I had put on a new catalytic converter.

I wish I could give it one and five stars at the same time. The muffler and pipes are great quality, beautiful bends and good gauge steel for the money. Also, I’m glad it’s made in America. Being stainless steel it should last way longer than Walker quiet rust as I like to call it. That being said the hardware it comes with is absolute garbage so throw it in the trash and buy your own hardware. All the OE original hangers are available on Amazon and I bought the clamps from a local automotive store. I will say you will have to cut the back end of the pipe that comes off the muffler about 2 inches cut it after the bend right by the leaf spring. This will enable the tail pipe to fit properly. I believe the tail paper is a quarter inch larger than OE so it may come in contact with the heat shield. I also had to trim that and the tailpipe at the end, which stuck out a few inches too long. With the modifications and clamp configuration, it takes twice as long to install than a true direct fit but I believe the quality is way better so this is worth it because it will last way longer than I believe.

It’s a generic over the axle bend for trucks. Terrible fitment and junk exhaust hangers.

Great quality and it fit my 1995 Jeep Cherokee Sport perfectly. The instructions were easy since they were labeled on the pipes so you can't lose them. I also liked that it came with the clamps and hangers. The muffler and pipes line up great and function like the original.

I used the old hanger in the back. Installation start to finish was about an hour including clean up. Sounds amazing and makes it sound like it's a v8 at lower rpms.

Perfect. Sounds great

Overall decent exhaust but keep in mine the original is 2" so you need a clip to convert that is not included. It also took some cutting to make it shorter to fit my "00 Jeep Cherokee. Sounds a little more aggressive than stock but doesn't drone out like a cherrybomb(which is a good thing). Says it's aluminized so we'll see how long it lasts!