Inline Type GFCI

Funciona bien

My Ryobi pressure washer came with one of those right angle 3 prong plugs which made using it with recessed outdoor outlets impractical. This has the straight-in style plug I needed and was an easy swap out (pay close attention to the wiring) and works fine. It doesn’t trip unnecessarily and looks and feels as solid as any other unit I’ve seen or used. It’s also handled some water overspray without incident.

Installed easily, it works. However, I have to press the reset button every time I plug it in to get the tool to work. The old plug didn't require this action.

So easy to install and then have a working unit again. I am not usually one to try this but the cost of a newpressure washer me try just adding the new plug and wham it worked.

Review for ELEGRP G1215CM2 GFCI; I dropped my 10 yr old Shurhold polisher and the GFCI on the end of the cord broke apart. Didn't want to pay $64 to have them replace it, I found this unit and it easily replaced the broken unit. Included are grommets for 18, 16 & 14 gauge wire plus the necessary screws. I chose the manual reset model, if there is an electrical issue I don't want a GFCI which automatically resets itself. After checking what caused the GFCI to trip I can press the reset button. The unit's size and shape is almost exactly the same size and shape of the Shurhold OEM unit. It states waterproof, while I did not test that claim the gasket between the two halves looks very similar to the original GFCI gasket, perhaps water resistant could be a better choice of words. This GFCI gives the polisher a like new professional look. It may take you more time for you find your screw drivers than actually replacing the GFCI.