Set Side Mirrors Assembly Fit for 1987-2002 For Jeep Wrangler with Half Door Manual Fold,Non-heated Manual Textured Black

Picked this up to replace my old side mirror and it’s just as good as the original. The install wasn’t the easiest, but that’s on my car since you have to take off a few panels, not the mirror itself. They didn’t have my color (my car’s gray), but I didn’t really care. Every other seller I seen was more expensive and had the same issue, so I went with black. Works perfect, stable, no shaking or cheap feel at all. For the price and quality, I’m more than happy with it.

Perfect for my impala 2012

Ok, before i puchased these I read reviews for these and others. Main issues were: studs not long enough and shaky. They all said that. This item, packaged really well looked great. The flip up on these is slightly stronger and harder to flip up then my OEM. (replaced due to non working motors and melted and warped due to sun) If you have mechanical skill and know how to pull door panels, this is super easy to do. I removed old ones to compare and matched perfect. studs were the same length. So I assume if you had issue with that you did not seat them fully because until seated one stud seems short. One drawback... the foam insulation between the mirror and door panel compared to oem was different. I saw what they were trying to do by lipping the foam over the edge which is not like oem. I removed those and re-used the oem ones, they fit better. Overall it was an easy install, super sturdy, no issues at all. Took me 20min. As to shakyness, seems fine so far but have not gone on the highway. Will edit if too shaky. (2006 ram)

These mirrors are fine. They work as I’d expect them to HOWEVER I am very “mechanically inclined” and was able to jump over the 2 minor hurdles that I’m reading many others are complaining about. That said if you’re driving a YJ you should probably be somewhat handy anyway as these vehicles are 30+ years old. 1) mirrors flop when driving fast - on the underside of the mirror housing are 3 tensioner screws. Tighten them. 2) mount bolts are too long for my 92 Wrangler. Cut them shorter with a dremel and cut off wheel. After these steps these mirrors are great for the money.

Mirrors are exact as promised quality looks great and also included nuts which I didn’t expect. Couldn’t ask for anything else due to price. Good product

You get what you pay for - The mirror motors stop and go. You have to stop and go to move the mirrors. Poor quality where they melt the pieces together, plastic broke on the inside where it was put together. I added an additional stick on spot mirror and as I pressed it onto the mirror, the mirror broke. LASTED 5 MONTHS...

Bolt right up everything fits and works looks excellent super easy to install there is no beating the price

Ahhhhhh…. Despite only needing the driver’s side mirror, I bought the two pack just so the mirrors would match. The fit? While they do match the mounting holes as needed, the rubber gasket to seal the mirror body seems a tad too thin, not very confident in the seal. The passenger mirror seems to mount flush to the door body. However, the driver side mirror that doesn’t quite go flush against the door frame, despite tightening the nuts/bolts as needed. There’s a noticeable gap at the top as shown in the pics. I’d love to get in touch with the seller to figure out how to rectify this, but I don’t see any link to contact them.