K90344 Sway Bar Links Fit For Lexus ES300 2002-2003,ES330,RX330,RX350,RX400h,RX450h 2010-2017;Avalon,Camry,Highlander,Solara,Venza 2002-2017 Front Stabilizer Bar End Link Suspension Kit

Great product

They came in quick. Good fitment

They worked perfectly in my car, good material and were easy to install

Took my car to a shop to have the suspension checked because of an occasional clunking sound, and they tracked it down to worn out sway bar links (or sway bar end links as they are also called) The old ones must have been on there for quite a while. They were a bear to remove, but I have a lot of tools, so after a couple of hours (!) I got them off. One bolt came right off with an impact wrench. On one I was able to break the link off the ball and use a bolt extractor on the ball. On the next the ball sheared off when I tried the same approach so I used a die grinder to carefully remove what was left. On the last, a lower one with very limited access, I ended up cutting the nut off very carefully with an 4.5" angle grinder with a metal cutting wheel. In hindsight the shop that inspected the suspension had given me a very fair quote to change these :D Installing the new ones was a breeze, and the clunking problem is solved. That makes me very happy.

Needed to replace my anti sway and bars, these were a good replacement, no issues with quality, easy to install.

Update!! Well its barely been a week and the lower lock nuts are coming loose, I drove the car monday about fifteen miles, then went out again tuesday to a neighbor and had a knocking. Drove again thursday knocking worse. Today took the drivers side wheel off and the lock nut on the lower ball joint has loosened. I had to re-tighten it over half a turn and believe me when I say I tightened them well. I think the nuts are not very good and the shaft may be a teeny bit short. Ordering a different brand today, will replace and return these. ---------- These replaced the originals one on my 2010 mercury mariner and fitted easily, I attach pictures of the old parts where the ball joints had degraded so badly you could move them with your thumb and the rubber boots were gone as well but they did last over 90,000 miles. Still this has eliminated the thunking noises I was hearing. I will point out that the ones removed had different size nuts on top and below plus the new ones were another size. Make sure you have a selection of wrenches from 14mm to 17mm plus a 5mm allen key to put in the center of the bolt to hold it when you tighten. You can use a socket on the top nut but I found not enough room on my car for the bottom one.

Easy install. Raise car front end up at the same time. Makes everything easier

Fit like a top

المنتج مصنع في الصين وليس في امريكا

Worked exactly as advertised. Fit perfectly. Thanks again.

This part was an exact fit for my Dodge Caravan and the part also came with grease fittings that some parts do not . Looks of good quality

Works as intended Not high end but The price reflects Time will tell how Long they last

Installed easy enough was a direct fit for my 2013 Mazda 5. Time will tell on quality as It's only been two weeks but so far so good 👍