RT-TCZ Fuel Filler Door Gas Tank Cap Cover Accessories for 2007-2017 Jeep Wrangler JK & Unlimited Sport Rubicon Sahara (US Flag)

When we bought our son his 2012 Jeep, the gas cover was missing. We bought this gas cover and it looks great and fits perfectly.

Fast shipment and arrived in good condition. Easy install, took about 25 minutes because of the removal of the old one, putting the rubber seal on the new one (I'm impatient) and interruptions. Other than that easy peasy. Be sure to make sure the door is flushed. You may have to push it in a little hard and be sure to tighten the hex screws. Great fit and quality was better than I expected. Good value!!!

*For reference, I have a 2016 Wrangler* I really like this fuel filler door. It looks great, feels sturdy, and was relatively easy to install. As others have said, the most difficult part was probably pushing out the tabs on the original piece. The instructions also weren’t much help, so I recommend watching a YouTube video if you're confused. The one major issue I had with installation was the pinhole on my car vs. the pin location on the fuel filler door. This pin is supposed to go into the pinhole to help with location/alignment and potentially prevent the door from spinning. For some reason, the pinhole on my car is at the top, while the pin on the door is on the left. I read only one other review that mentioned this issue too, so maybe Jeep just messed up on our cars. But if this happens to you too, you can just drill a hole for the pin (I used a caliper to determine the drilling location but a ruler would be fine). However, I have 2 complaints. First, the pin actually broke off. The tabs are tight enough to keep it from free spinning but not so tight that it wont rotate from time to time. I don't anticipate this being a major problem but it was annoying since I drilled the pinhole in hopes that this wouldn't happen. Second, the door rim doesn't actually sit flush with my car. Again, not a big deal but just a little annoying because it feels like it doesn't fit as well as it should. Overall, I decided to keep it because it gets the job done and I like how it looks. I knocked off one star for both my complaints since they're relatively minor, but I will be keeping my OEM piece in case anything happens with this.

Was easy to install, directions were simple. It helps dress up my jeep.

Made my jeep look great. Easy to install. Price is perfect.

Great well fit product made with sturdy material. Nothing cheap while worth the price would highly recommend.

This was a relatively easy install. There are directions and a video to watch on the page where you buy this. Very helpful. A couple tips. You only have to remove the two right hand screws to remove the back light. I didn't even unplug it as shown. I used a large screwdriver to push in the buttons on the existing gas cap assembly. After undoing the two clips there is a third. Push the assembly towards the back of the car and the old assembly will be able to pull off. After that it is easy. Put the gasket on. Use your old one as a guide. Push on new assembly until it clicks. They give you extra screws if you drop one. Also the top and bottom screws do not need to be removed as they are for show. If you remove these two screws there are nuts attached. Do not loose as you don't get extra of these!!! Looks great.

This part fits up just fine. At first it appeared to be a great product. But the Flag emblem on the lid faded off, during the winter months, you can't even see it. So now I just have flat black colored gas door. But at least the gas cap is covered up. So there is that.

Facil de instalar muy resistente, calza perfectamente con la carroceria, muy buenos materiales ademas de bonita

Looks good and the seal was the correct version; happy with the product. My only wish is for the lock to be more sturdy, potentially protecting against someone trying to pry the door open with excess force.

🩷 me encantó

This product was well worth the price. Very simple instructions, and everything needed for the installation came in the package.

After 6 months the cap was starting to corrode but I left it on. This is what it looks like 16 months after purchase. Will take it off shortly sand it down and recoat it as its beyond bad now.