10T Hydraulic Gear Puller Set Wheel Bearing Puller Kit 2 or 3 Jaws Pulling Separator for Wheel Hubs Rotors Car Axles Pulleys Brake Drums (10 inch JAW)

I needed a puller to remove the flywheel from the crankshaft of an antique car. I was concerned that the puller might not be able to fit the 3 inch hub of the flywheel, but it did so easily, and I quickly got the flywheel off. A great tool!

Works really great and pull the bearings I need to get out and I’ll use that many times in the future

I have a 2009 Hummer H3t alpha. 15 years of rust and build up in there. My bearing hub assembly was completely shot. The bearing was completely gone. This was a life saver. I needed all 10 tons of pressure to get my axle out of the hub which was essentially free floating with the axle rusted inside. This is incredible value. I got a torque gear press from an auto parts store for $25 it failed almost immediately. The shorty little metal arm joints snapped opened with barely any pressure. I would buy this thing 100x over for how much this saved my a**!

I liked the power but the throw was so short I had to improvise with a socket. I wish that the video was more honest. I would have saved time. Once I got to get the hub assembly to move the hub moved this thing had actually bent the hub. Worth it yes. I tried heat I tried penetrating fluid to get everything off I did everything that any normal person would do. Yes it was heavy for one person to use but if you use a jack stand to hold it up while you are positioning it and putting pressure on you'll be fine. If the two if you have two people then it makes everything there's a lot easier but I did not have the option. What are the recommend this to others yes but you had better either have somebody help you and remember that's only a 2-inch throw. I am still glad I had bought this piece of equipment because I will use it again.

Pulled a rear disc on a 2016 Town and Country. I chose the 15 ton version simply because I have experienced too many tools that were just not capable of doing the required job. A heavier version is always money well spent.The only restriction is the 2" travel limit. With the deep pocket in the hub, I had to use a 2" length of 1/2 steel pipe to be able to get a set-up that would work. Then, popped the disc right off.

Bought this for a project and ended up not needing it. Sat on the shelf til today where I needed to pull a mower idler pulley that was locked on tight. This made the job effortless! Great power and overall decent build quality for the price!

Product worked great pressing out my stuck cv axle that i spent over an hour on pounding on the shaft my my heavy duty air hammer and 5 pound sledge hammer to no avail. I ordered this product as a hail mary attempt to remove the stuck axle from my hub. Side note, this will take two people to use as holding everything in place with one hand isnt possible and pumping the handle with the other.Once i had the tool setup and in place 4 pumps and two loud pops later the axle was free. Took 20 seconds to free it up. Will worth the money spent.

worked great at removing 12" rusted on drums on 1998 toyota sienna. I previously tried 8mm x 1.25 bolt, hammer, lots of PB penetrating oil, bigger hammer, sledge hammer, & propane torch; all failed, but this puller popped them off easily.There was a mildly putrid odor from a thin layer of oil applied to the housing, but that disappeared in a day.strongly recommended.