Gas Grill Replacement Parts Manifold Main Burner Control Valve for Weber Genesis 300 Series(2011-2016) & Genesis II E-210 / E-310 / E-410 (Propane(LP))

Fit perfectly on my Weber Genesis 300. Took a minute to install once old one removed.

Valve fit and functioned perfect. Both gaskets were included and worked as expected. Fixed my grills issue.

perfect replacement part.

Seems exactly as the original, a perfect fit. Works fine!

Bought these to replace My OEM Weber parts, fit as expected and working perfectly.

Was an easy fit and works perfectly. The only difference from the original design is the screw size.

Worked great and was 1/2 the cost

A very common break... Grill blows over, or gets damaged while moving. The knobs make contact and the valve stem breaks off underneath. Weber does not sell individual valves nor the stem pieces only - they require that you purchase an entire manifold and replacing all three gas valves and the housing, wanting $120 or more, part number 70055. This part from Amazon was just what I needed. When you remove the rubber cover, and remove the two screws in this part (t10 Star heads), you simply change out the stem, stem housing and the spring underneath. About a 5 minute job max. This is an exact match OEM part of the original. The grill in question is a Genesis 310 from 2013 and this part fit exactly. You do not need the remaining part of the entire valve from this product as shown in the 4th photo. you only need that stem piece, the two screws and the spring underneath.

Easy enough to replace

Passar perfekt till min grill Genesis S330

Works fine. Major wind blew BBQ over, smashing control valve. Replaced with this unit, now as new (And secured to deck)

Great fit for my Weber Genesis. Works great

Passt perfekt in den Weber Genesis E330 GBS Modell 2016. Vom Original nicht zu unterscheiden, regelt wie es soll. Für den Ausbau müssen lediglich 2 Schrauben der Verblendung an der Unterseite der Bedienplatte gelöst werden, dann die Befestigungsschraube im Brennraum des jeweiligen Brennerrohres (dies zur leicht zur Seite und nach hinten wegziehen, Bedienknopf abziehen, dann die Schraube unterhalb am Verteiler des zu tauschenden Regelventils lösen und das alte Ventil durch das vordere Loch hinausführen. Einbau in umgekehrter Reihenfolge. Anleitung nur als Hilfestellung und ohne Gewähr oder Garantie auf Erfolg.