- TRUEGRID | PRO LITE Permeable Paver | Driveway, Grass, Shed Base, Patio, RV Pad, Gravel, DIY Outdoor | 120,000 lb Load Class | All-Weather | Easy Install | Pack of 18 (72 Square Feet)

I figured out how to make the path curve AFTER putting the first 35 feet down. At first I offset them, and that looks GREAT, but it also makes for a more narrow path.... I made a pathway through my woods just one tile wide, and that's not a lot. Major paths should be 2 squares wide with smaller paths one tile wide. Oh well, looks great. Water flows over and through the gravel, and I'm not dealing with mud anymore, which was the purpose of this project. Once I layed the next 4 boxes, I figured out the S pieces in the tiles allow for curving the path. You need to put a tile down, lock in place, put gravel down on the last tile, then push the tile into position, and place a big rock to KEEP the tile in place... dump gravel, and keep moving. Make sure you don't put too much gravel down at first. You want the grid to hold the gravel in place, so water and blowers don't move it around. If you need to move the tiles AFTER you put down gravel, there's no good way to DO that IF you have to lift a tile to get the last tile UP, so 90% research, and 10% execution. Plan this out. Order what you need. A ton of gravel covers about 200sq ft at 1 inch depth. Make sure you have the gravel dumped in a place that's convenient to your project and not in the way.. I put a tarp down first, and that was a good choice. Crushed river rock looks great for my purposes. I put medium, large, and small rocks on either side of the trail.... thicker on one side, then the other to enhance the appearance of a meandering trail... just lovely! This product isn't cheap, but it's forever, and it's solid. No more time and money wasted on pine straw. I also down a path on my somewhat steep hill. It's in the rock garden, and matches the stones perfectly. I have a flat surface to walk, roll a wheelbarrow, etc. It was a 2 day job.... one day to put down the grid. A day to fill with gravel, and place rocks back.

So far, I have used it in three applications. One was in front of a shop in my backyard where water stood after a rain. I put a layer of white rock, then the TrueGrid Pavers, and filled them with angled black rock. No more water problems, and looks good. Had a number of tree roots I had to work around, and the TrueGrid pavers were easy to fit using a skill saw. The second application was on a walkway to a grill in my backyard. As the walkway approached the deck the grill sat on it sloped down. Problem - this would accumulate water. Put the TrueGrid pavers down, and again cut them easily to fit the form of the walkway. Put rubber pavers over the True Grid pavers. Ended up solving the water problem by lifting the walkway and yet providing drainage since the TrueGrid pavers are about one inch. Used no gravel in these and yet the walkway over them is solid. You would not know the rubber pavers were not on solid ground. The third application was to extend my driveway. Again, the problem was drainage, and in this case, if cars parked there, ruts. I had thought about using regular pavers, but there are are a bunch of roots and I would have had to dig deep enough to make a base of sand for the pavers and the width of whatever pavers I used. Digging down through roots three to four inches did not sound appealing. With concrete, again there is the problem of digging far enough down to lay a good base and use either wire or rebar. Then there is the work involved in mining the cement. Using the TrueGrid pavers I only had to go down one inch, level the ground, lay the pavers on it and fill them with angled black rock. Works perfectly. Heavy pickups can park on it with no. give, no ruts, and yet it allows excellent drainage. Glad I found this stuff. I have some other projects I intend to use it on. Check out their web site for examples of personal and commercial use and it will also give ideas as different ways it can be used. No, I do not work for them nor receive any compensation for this review - it's just good stuff and made right here in the Houston, Texas, area.

Absolutely love this product. I ordered 3 boxes of these 2 years ago waiting to get this project done but finally got around to it after the boxes were collecting dust in the garage. They are very solid and easy to install. I found them a breeze to cut through with a sawzall. They were easy to interlock and I really appreciate the flex. I have a high traffic area I was going to put 1/2” crushed gravel in and wanted the extra stability and not have to take gravel all the time. These absolutely keep the gravel in place and give a really solid feeling underfoot. I put a little extra gravel on the top as to not see the grid and it looks great. I didn’t try too hard to level/grade prior and it’s been working out great. The hardest part was moving the gravel. In the future I’ll never lay gravel without this.

I used these for a small driveway/patio access area that needed to be fully permeable to surface water. Installation was completed by excavating into the rocky/gravely clay subsoil, leveling the area was a challenge but provided an excellent base for woven geotechnical fabric and paver installation. The TrueGrid units installed easily by using a table saw to rip down grids to the correct dimensions and click together in place. Steel landscaping staples were applied on the crossbar cells, then over filled with 3/4" crushed gravel, raked to level surface and compacted. This creates a very stable surface for rolling tires: bikes, cars and trucks. As we progressed into our project I used a skid-steer loader to distribute gravel and topsoil. This was fine for straight travel over the new sections of TrueGrid/gravel, turning a skid-steer on this surface was too much lateral torque and the grids were ripped up underneath, torn and fully exposed. A skid-steer moves by turning the right and left wheels in unison, independently or in opposite directions simultaneously. This was along the edge of the installation, where they were unsupported by neighboring grids, along an interface with concrete slab. In fairness, the same maneuver in loose gravel would have displaced a lot of rock. When the grids are displaced gravel immediately gets underneath and creates a raised section that only exacerbates the problem. It quickly becomes an unstable slip plane extending like a blister under the grids. With continued use the affected grids are completely torn out of the installation (see reference photo where I have removed some of the surrounding gravel to expose the affected grids.. While it was only 2 sections of grid that were displaced, the repair work to restore a level surface was not easy. Fortunately I had a few leftover grids from the original installation. I found it was easiest to cut out the interlocking tabs with an oscillating saw, then remove the damaged sections. The gravel must be completely excavated from the affected grid area in order to repeat the installation process. If I had to do it again, I would use an empty shop vac to clear the gravel. It took me about 2 hours to remove and fully reinstall two grid sections. Note to buyer: load ratings are apparently only for typical unidirectional-drive rolling vehicles, this product did not hold up under significant lateral/twisting loads. For the time and money, this product improves a permeable gravel surface application giving greater stability and expectation for longer gravel retention if installed with fabric underlayment. This is ideal for applications where improving groundwater replenishment and reduction of stormwater runoff is desired, or to establish a quick and reasonably stable ground surface. If it is displaced, expect a long and challenging process to repair, unlike a traditional gravel roadbed—you can't just rake it out level again.

I am in love with these!!! I have a 140 pound Anatolian shepherd who has all but turned my yard into a horse paddock. I was mopping constantly. The mud, dirt and dust were ridiculous. She could use her back feet to sent hunks of sod flying 40 feet. I am not exaggerating! She ran a mud track into yard where previously grass had flourished. Just moving around she did more damage than when I had three large dogs at once. Oh and she digs! Lol. I tried just about everything, including soap stone and gravel, which she just shot around my yard like shrapnel. Not to mention walking on it was like walking through quicksand. Then I got these. They saved my yard! They were so simple and easy to put together I was able to do it while still on restrictions after reconstructive surgery. The box they come in is heavy and awkward so you may need to flip it on take them out a fee at a time but they click together so easily. The material is forgiving if your surface is not completely level. They cut easily with garden shears or tin snips. Do be careful to line them all up in the same direction! These grids now hold gravel, stone and sod in my yard. Every surface is a sturdy as cement and my darling puppy can't seem to destroy them. I've purchased two packs and installed them in the two areas she likes to dig, under all the gravel and along half her running path. I wanted to see if they would work under sod before I bought a third set and they do!!! These are not cheap, but if I could give them stars I would. They have saved my yard and my house from a failed service dog turned rogue yard warrior.

Awesome product. I have used these to create a patio-like seating/grilling area in my back yard, a handicap accessible walkway from the front of the house to the back Truegrid patio, and as base pads for 3 RVs (under tires and under jacks). They look good, especially with your favorite color of gravel in them, and they hold up very well. Expect weed growth eventually (even with weed cloth or cardboard underneath), and consider using "gravel glue" if you add gravel to prevent it from getting into the cleats of your shoes. All in all, this is an amazing product!

I purchased this product to construct a patio in place of a hot tub which I had removed--initially I was looking at concrete pavers, but I have 3 mature trees near the spot and the roots are way too dense to dig a conventional foundation. With these, I just graded the site roughly level, laid the tiles down, dumped gravel in, and raked it in, just as advertised. This product, half a cubic yard of pea gravel and a bit of landscape fabric, a wheelbarrow to get the gravel from my truck to the site, and a couple basic tools to spread the gravel really was all that was needed. I wasn't sure what to expect with respect to the surface--I would have imagined that pea gravel would shift underfoot quite a bit, but with the grids in place, standing on it definitely feels very planted. It definitely exceeded my expectations in that regard. The plastic is very thick, and quite sturdy, and the tabs snap together securely but don't require tools to click into place (which is impressive from a manufacturing tolerances perspective). If you need to cut the tiles to make a more complicated shape, you probably can do that, but power tools would likely be required. At about $2.50 per square foot, the price seems steep, but I think they're going to be worth it in the end. Overall, as of the day after the install, I couldn't be more pleased. I'll update the review if that changes, but as of now, it's great.

Great product I highly recommend if you are in need to build a foundation but do not want the hassle of needing a permit to pour concrete these work as well as a concrete foundation and they drain very well. I used them under my synthetic golf green and my garden shed as a foundation I couldn’t be happier.