Camco Rhino RV Tote Tank Nylon Cover Accessory with Cinch Strap, Elastic Edges, and Water Drainage Grommet for 28 and 36-Gallon Tanks, Large, Gray

Cracked the original wheels after three years. The inner bearings ripped out. Purchased these front wheels and received them in a day and a half. Took around a minute to reinstall. They are sturdier than the original and work as advertised.

This Rhino Tote Tank Tow Adapter is a solid replacement part that’s really made a difference for me. I have the Camco Rhino 36-gallon portable septic tank, and when it’s full, it gets seriously heavy. While the tank has a handle to roll it like a suitcase, that only helps so much when it’s full. What I like about this adapter is how sturdy it feels. It’s made from black powder-coated steel, so it’s built to last. I feel confident hooking it up to my John Deere and towing the tank to the dump site without worrying about it breaking or coming loose. The 3-inch tow loop fits well on my hitch ball and makes moving the tank much easier. This adapter lets you tow the tank behind a UTV, truck, or other vehicle at slow speeds. For something this heavy and awkward, being able to tow it instead of carrying or rolling it by hand is a huge convenience. I honestly didn’t realize how much I needed this until I got it. Now, I wouldn’t be without it. If you have a Camco Rhino Tote Tank and want to save your back, this adapter is worth every penny. Five stars from me.

Worked great on our camper and easy to mount the rhino wheeled dump

It looked like a simple installation but as typical of my projects I ran into a little glitch...not too serious but a little annoying. The base of the two stand uprights are supposed to lay across the top of the bumper and extend back a little way under the camper body and then the u-bolts go over the part lying across the bumper and secure it to a steel plate under the bumper. This assumes that the bumper either sits far enough back for the upright to have enough room for the u-bolt to fit before contacting the rear of the RV or the bumper is low enough that the upright will lay across the bumper and extend under the RV. On my trailer the top of the bumper was about even with the bottom of the trailer and close enough that there barely was enough room for the u-bolt to fit behind the bumper. With the rear u-bolt in place it was so close to the end of the upright that it would slip off while tightening the bolt. My solution was to install a bolt on top of the upright near the end to serve as a stop to keep the bracket from sliding off when tightened. See attached pics. That worked fine. The black paint on the steel plate that goes under the bumper was flaking off in places so I am sure I will have to touch that up to prevent rust. A couple of cam buckle straps were provided but I could not get them to hold as firmly as I like so I will be adding some better ratchet straps. Overall this tote carrier seems sturdy and well made and I am satisfied with it.

Worked great easy fittings

This is a back changer, before on my tank I would have to lift that 36 gallon tank on to my tow hitch and the weight of a 36 gallon It’s very heavy this Dolly took the work right out of it handles and maneuver great and it’s good quality, part and fitment was perfect. Installation was simple done within five minutes so very simple job to install

It met all expectations!!

It is what it is and works exactly as described