50 Amp 6-50R Outlet Box 250 Volt, Enclosed Lockable Weatherproof Outdoor Electrical NEMA 6-50R Receptacle Panel Heavy Duty Box Pre-Drilled, For Welder EV RV Electric Car Generator, ETL Listed

Solid construction, ran 6Ga no problem, wired my EV after a year... previous used for charging a few electric unicycles (each can pull 2.4Kw), non-issue running 9.6Kw EV Charger.

Would be very nice if the front flap would detent in the up position as well as in the closed position. During installation I used a magnet to hold it open.

I like the individual plates with knock outs already punched but they aren't interchangeable with the one on the top. I used the one on the top with a Meyers Hub for a clean installation with the raceway coming down from above. The box is very sturdy and has a ball and detent that hold the cover closed. Bubbled cover is nice too so that a plug with a handle will fit into it.Also, if you're not aware, a 6-50R is only 250vac, so no neutral meaning this isn't any good for a 50Amp RV plug. I didn't care beacause I was going to change it out with something better anyway. I purchased a Leviton 125/250vac receptacle which is a 14-50R and used that because I know and trust the Leviton brand products.

Great setup

yea, perfect. honestly the issues i have are about the 6 gauge wire than its about the box, looks good to on the wall.

Perfect! this will be used for my welder. I can leave it plugged in and its still weather proof

works well for my arc gouger

Wire mounting screws are tiny and strip, require splitting wire anything over 10ga, don't even thing about 8ga. This is a no no. Box is unnecessarily long. Conduit holes are not punch out type and require tool or drilling. Pass. You can piece something better from HD or Lowes parts for cheaper.