Moxweyeni 75 Inches Flexible Magnetic Strip 3/8" Width 1/8" Thickness Insert Shower Door Magnetic Strip Replacement Magnet Shower Door Replacement Parts for Framed Semi Framed Swinging Glass(1 Roll)

I have a 25 year old shower door that stopped staying closed. Then pieces of the magnetic strip started breaking off and falling out. I was worried I would need a new door. Instead, I ordered these strips. It was a tight fit getting them to slide in. I didn't want to loosen them too much but I found a bit of liquid soap worked well. The magnet works so well I have to put a bit of pressure now, to get the door to open. I am going to use caps now. Please don't think I'm shouting. I just want everyone to know ... These strips look identical. They are polarized down one side. There is a small groove in the rubber to indicate this. WHEN HUNG THE GROOVE ON THE DOOR PIECE AND THE GROOVE ON THE FRAME PIECE NEED TO BE ON OPPOSITE SIDES. If you feel the magnet is weak or not holding double check that you have not accidentally installed them groove to groove.

The product is adequate for its intended use and was easy enough to install. Please note: 1- before you order this product, be sure if you need the type of magnetic strips that slide into a grove or need to be self-adhesive... this is the type that slides into a track or groove in the door frame and is NOT self-adhesive. 2- There is a groove in the face of the magnetic strip that indicates polarity... pay attention to its position when inserting it into track. 3- Be aware the the magnets must be inserted with opposite polarities facing each other or they will not work right and will actually repel each other... I see reviews where people don't seem to understand this... before you install it test which way they must install and if it seems like they are not attracting towards each other, flip ONE around.

Profile was not an exact match, but seals well. Length was just shy of 75", but long enough for my door. If you need the full length, be aware. If not replacing both strips, don't trust the groove. Check polarity against side that's staying. In my case, groove of old and new had to be on same side to work. Good value, would buy this again if needed.

Worked great going into the channel . However I noticed playing around with it before installing it would magnify to itself which made me feel it’s not going to stick to my existing shower magnet . Once installed on the door the door wouldn’t stay closed . I need to replace the other side so I ordered another roll . Would have been cheaper to buy the two rolls and replace both sides at the same time . I had some left over so I added the left over 8 inches and the door will close till the other roll comes in . In summary buy two rolls and replace the door and shower side at the same time(my fault for rushing to save 1$ and now spending another 14 ) Still giving 5 stars

Install was relatively painless. Remove old strip, slide new one in after making sure attraction between magnet faces would adhere. Now the door with the new strip won't grab the frame to stay closed. I'm at a loss. Guess I'll get stronger magnets.

Exactly what I needed to replace my old crumbling cracked door magnets. Tightly holds the shower door closed.

While this was easy to install, it slides right out every time you open the door.

After reading a few ratings before buying, I checked the polarity of the magnets and placed them in my shower door. Now my door closes tightly and water does not leak out. It was rather a struggle to get it in the door, however, as I could not slide them in. My doors have blocking elements on both the top and bottom.

Very disappointed that the 2 rolls of magnetic tape, or not magnetic. Do not stick to each other, or to any steel surface tried subsequently.

It fits, easy to install and it works.

very good product