Question 1

I have a cr10s, do i need right hand or left hand??

Accepted Answer

All the ender 3 and cr10 series need the right version!!

Question 2

Will this work with anet a8 plus? and what version would i need to buy?

Accepted Answer

You're having trouble with YOUR extruder, too, aren't you? We all are. They're terrible.

This will work with your printer if you're fed up with their direct drive and you're converting it to use a Bowden tube. Be aware that Bowden tube extruders come with their  own unique struggles, but they're not as nasty as the A8 Plus's direct drive extruders.

Since you're doing this conversion, you'll also need some sort of 24V Bowden-style hotend.

It mattereth not a whit whether you go with the left-hand or right-hand version for your printer; you'll mount it wherever you figure it'll be convenient. If I were you, I'd mount it somewhere left of center, but your circumstances may be different from mine.

While you're at it, you might as well upgrade your linear bearings to polymer, too, and your control board to one of the many alternatives. Whatever you do, don't screw around; replace that power cable NOW before you burn your printer to a crisp! The one that runs from the power supply to the control board. It isn't big enough for that load, and the crimped terminals sometimes catch fire. Replace it with no less than #16 AWG wire.

Question 3

Will this fit a Monoprice Mini v2?

Accepted Answer

It's designed for the Creality CR-10, but it's a fairly safe bet that it would fit any bowden printer that uses the same size motor for the extruder, and the same size filament (The creality uses a 42-40 stepper motor, but many other stepper motors have the same spacing between screw holes).  Depending on the bracket the motor is attached to, it's possible the screws that come with this part might not be long enough, but replacement screws shouldn't be hard to find.

Question 4

Is this all i need to upgrade an ender 3 to have a metal hotend for printing petg?

Accepted Answer

You don't need an all-metal hotend for petg usually. The one on the ender-3 will work just fine. The limit of a ptfe tube is around 240-250. Petg prints with a hotend at 230-250 usually, just make sure the filament you buy isn't one of the odd ones that might need higher temps. If you're worried replace the ptfe on your ender-3 with high grade stuff like capricorn and look for lower temp petg filaments.

ASIN	B09H6T3NNT
Are batteries included?	No
Best Sellers Rank	#172,469 in Industrial & Scientific ( See Top 100 in Industrial & Scientific ) #373 in 3D Printers
Brand	Redrex
Compatible Device	Laptop, Personal Computer, Smartphone
Country of Origin	USA
Customer Reviews	4.4 4.4 out of 5 stars (1,753)
Date First Available	8 November 2021
Item Dimensions LxWxH	25 x 56 x 50 Millimeters
Item Height	5 Centimeters
Item Weight	59 g
Item Width	5.6 Centimeters
Item model number	RDX3D032
Manufacturer	Redrex
Model number	RDX3D032
Number of Memory Sticks	1
Product Dimensions	2.5 x 5.6 x 5 cm; 59 g

Dual Gear Ender 3 Extruder with Two Washers Metal Drive Feeder Upgrade Kit Compatible with Creality Ender 3 V2 Pro,Ender 3 Neo Series,CR10 3D Printer TPU Filament Supported(Motor Shaft>21.5mm)

Description

Specifications

Common Questions