Proster 4mm Banana Plug to Alligator Clip - 15A 1000V Pure Copper Flexible Electrical Test Cable One Meter for Multimeter Electrical Clamp Meter Testing

They fit my multi meter and are flexible. The alligator clips are sturdy. Overall a nice set of leads

I have a few Harbor Freight multimeters that they used to regularly give away. For simple stuff those inexpensive multimeters work great. No need for my Fluke. But the Harbor Freight leads are TERRIBLE. They frequently break and I was told replacement leads at Harbor Freight are the same ones. No good. These leads fit Harbor Freight Multimeter PERFECTLY. Finding replacements was actually a bit hard but not anymore.

This product saved the day for me. I needed a clamp cable to establish a vehicle ground for my multimeter. The product is just what I needed. It’s the right length, good quality and nice value. All this is enhanced by getting delivery quickly along with other items I needed. No one else can provide a solution like this and must be a principal reason for Amazon’s success.

Received, unpacked and used them. The 15th of Dec. was the first time that I have used these. And they work well for me. Well satisfied with them.

These are very nice quality test leads. The alligator clips are solid, well built and not at all flimsy. The ends are well stress relieved. The wire is heavy gauge but very flexible so they're using fine copper wires with a high overlap angle, as intended for continuous flex applications. These test leads will not fatigue fail internally from too much bending. This is a quality that I'm accustomed from seeing from Fluke, HP or Tektronix.

Nice Product! Good Quality and has rubber on wires and is flexible not cheap plastic...Highly recommend.

I added these alligator clips to my FLUKE. Direct fit and hold very well. Quality and good construction!

I used the leads the day that they were dropped on our front porch. They are very flexible & the grip the object to be measured very well. I made some low resistance measurements of a new small AC dryer motor & they came out close to the correct value. I soldered four 1% 1 ohm resistors together with buss wire & measured the four connections that read out within 1% of the value shown. I would buy the test leads again if I need of them again. Thanks for your good work.