True MODS 5 Pack Bosch Style 5-Pin 12V Relay Kit [60/80 Amp Heavy Duty] [Interlocking Harness Socket Holder] [12 AWG Hot Wires] [SPDT] 12 Volt Automotive Relays for Auto Fan Cars

I bought these to wire up electric fans on a car I was working on. Worked great, very happy with them

This worked great for the installation of an LED light bar. The price was good and now I have some extras for lighting expansion in the future if I want. Would recommend.

They are grate

I purchased these to hook up a 50 amp electric cooling fan in my car. The factory fan controller died and I needed a low-cost solution to get it spinning. These have heavier gauge wire on the leads intended for the load, so they can actually handle the rated 60/80 amps. I wired one directly to the fan circuit and an ignition-switched power source. I didn't use any additional electronics, it kicks on the full load immediately and runs at 100% all the time. It's held up fine for over a month now in the heat of summer, so if it was overrated, it would have blown by now.

They have worked so well on other Hi load circuits I find myself buying more for other failing relays. Dual 30 amp fan circuits with one relay per fan. Yes may be redundant but tired of burning up 40 amp Hella relays. Repeat purchases of know good products works for my. They are very tight in the connector and larger pined than the standard Bosch style relays. Definitely recommend if you dont want problems. IMO would stay under the 60 amp rating being they are locked in continuously while running vehicle AAA+++

Hard to plug the socket onto relay. But it is very secure afterwards . I had 1 to stick in the normally open position once. But ok for now, working good.

The results work great! I'm using them on the electric fan set up on my pickup. I like how the sockets lock into each other. It makes it very convenient for mounting. Only thing I,could say that is a bit of a pain is the relays are very hard to plug in but on the flip side they will never vibrate loose.

Great value for the money! I used them to repair the cooling fan and a/c compressor relays on an older Mazda Miata. They work great and the relay connectors interlock together for a nice clean look. Relay terminals are larger (not the relay) than most automotive applications due to the higher amperage rating. I would consider these to be Heavy Duty relays for automotive application.