15W Qi Wireless Charger PCBA Circuit Board with Coil Pad Charging

It works as advertised without problem, it is only the transmitter side of the duo, so you need to order a receiver if this is not simply to replace a transmitter unit. Also doesn't come with a charger cord or block, so will need a power block and usb-c cord to power it.

I have been having so much fun imagining all the different ways I could put them into a fixed state that matches my decor!

No instructions and the wires connecting the usb to the coil are super short. I had to extend them which worked but wasn't exactly easy. The thing works though and was more durable to work with than I expected.

Works better than expected. Reliably connected, charged and stopped on completion of charge cycle. Will be used embedded in surface.

I bought this to build it into a hidden wireless charger under of a thin plastic sheet, but this is not a good product for that. It barely charges my iPhone 16 pro without a case. I measured it and it seems to only pull 9v 0a which is why it won’t charge. The build quality is good for the price, but it just doesn’t really work lol.

As received the charging coil assembly is smaller than shown in the picture. Specifically the ferrite puck is the diameter of the wire coil, where in the picture the ferrite is shown to overhang the coil.

These sometimes work if you place your phone on the bare coil just right but do not work at all if you intend to mount these behind anything. They don't even work behind thin cardboard. That's the whole point of buying these in bare form so that you can use them in DIY projects.

Used these for a radio in my car. There was a small pocket left under my aftermarket head unit so I drilled holes in it and dropped these guys in there! They work great and held up so far.. been 2 months and not one issue!