Annular Cutter Set 13 Pcs by S&F STEAD & FAST, Cutting Depth 1" Cutting Diameter 7/16" to 1-1/16" Inch, Mag Drill Bits Kit for Magnetic Drill Press, with 2 Pilot Pins

This annular cutting set has paid for itself over and over. As a professional welder and metal fabricator, I rely on precision and efficiency, and these cutters have delivered both without fail. Whether I'm drilling through thick metal for custom trailer builds or fabricating complex structures, these cutters have proven absolutely essential. I've put them through their paces on heavy steel, and they cut clean, precise holes every time. No overheating, no dulling out prematurely—just consistent, high-quality performance. For the price, they’ve far exceeded my expectations. If you’re serious about metal fabrication, this set is a must-have. It’s durable, dependable, and has become an irreplaceable part of my shop.

Very sharp, works well

Great value for the money. I used this kit to drill holes for my welding fixture table. Drilled over 200 5/8" holes in 1/2" plate steel and the bit still works like new. I did use a drop of dark cutting oil before each cut. Drilled cleanly and worked great

I have been wanting to get an annular cutter set for a very long time. Most annular cutter sets are intended for use in mag drills. I do not have a mag drill but I do have a vertical mill. I put the annular cutter into a 3/4" collet (using 3/4" cutter), set the rpm's to roughly 100 and started feeding into a piece of 3/16" tube steel. The cutter went through like hot butter, the biggest issue was the need to stop the process to break the long burrs that started becoming dangerous. Since I was using a 3/4" collet and the mill, I did not have a spring for the point, the slug still came out of the cutter with very little effort. Eventually I may make a tool for inside the collet to use the plunger to remove the plug. But overall, I will never go back to using a drill bit again. The entry side was the cleanest I have ever had and the exit side left almost no burrs. The pictures attached are immediately after the cut without any processing to remove the burrs.

Cuts mild steel like butter. Center punch knocks out the core every time. A pleasure to use in a mag drill. Very nice case.

Very clean, organized, and well made tools. They cut very well and I will highly recommend to anyone needing annular bits.

Super clean cuts with mag drill. Shocked to have zero burrs on top and underside of holes through 3/8 steel. Stayed cooling when drilling. Staying super sharp after 20 holes

cheaper than anywhere I could find them and they are high quality