1 Inch Rear Lift Blocks for 1995-2023 Tacoma / 2000-2021 Tundra | 1" Rear Lift Kit Fit Tacoma Tundra 2WD 4WD Factory Leaf Spring Axle, Aluminum Leveling Blocks Raise the Rear of Truck by 1"

These blocks are the best I've ever seen. You won't belive it when you get yours. SOLID aluminum!!. Heavy. You could eaven machine them with a taper to correct pinion angle if needed. I bought the 3" ones to lower my 58 t bird.

Worked well for my 2006 Toyota Tacoma. Been running them for a year. YOU WILL NEED U-BOLTS

Installed on my Tacoma. Bolted right on, probably only 20 minutes to do both sides.

They worked great on my Frontier. I did have to knock off about 1/8 off the centering pins.

Delo mejor

My '15 Tacoma just turned 150,000 miles and I wanted to refresh the front suspension with TRD Off-Road coilovers from a 3rd gen. Because the swap adds about an inch of height in the front, I used these MZS blocks to keep some semblance of factory rake. With a hydraulic jack and some jack stands, these are super easy to install. The only tricky part was using my feet to push on the leaf springs to align them properly with the hole on each blocks while raising the axle back into place. I like that these are solid construction.

Fit great

They fit good on the Tacoma, gives it an inch on lift

Good product thank you

This block worked for me but I had to buy longer U-bolts as they are not included.

You will need new U bolts, wish I had known that prior to getting just the blocks