HONEYTEK A6243L Digital Inductance Meter Electronic Capacitance Tester Inductance/Capacitor Test Table

I tried it out on some capacitors that I have and the values were way off. However, I tried measuring with another, less accurate meter and it agreed well with the meter that the marking on the capacitor was way off. Since this meter has better claimed precision, I'll give it the benefit of the doubt of being more accurate until I can find a precision capacitor to measure against. I will also try the inductor measurements now.One gripe was that the screw on the battery compartment was over-tightened and could not be opened with the tiny screwdriver provided. Fortunately, I had a somewhat larger screwdriver that worked.

Meter would not provide any readings when I first installed the leads that come with it. Thought it was a dud. Leads didn't feel quite right when pushed into the meter, so swapped with leads from another meter and measured capacitors again, this time meter worked like a charm. I had to trim some of the insulation from around the male end of each lead because they were not making contact where you plug the leads into the meter. Other than that, this is a nice little meter.

Decent meter, but not as accurate as it claims. First, in the low range, it is off by about 10 microH. I measure a known standard coil of 2.2 uH and it shows as -7. 10 uH reads as 0.0. Even in the upper ranges, it's off by a fair bit. 68 mH reads as 59.The capacitance measurements have similar accuracy issues. It is consistently low. A 0.1 uF 2% precision capacitor measures at 0.075Overall, this meter is worth the money and will get you a reading in the ballpark but it's accuracy is commensurate with its price.Note that I used the cx/lx socket and not the probes since those will introduce reactance.

Need something to measure microhenry now is the time

Easy to read and use, the only criticism is that the test leads supplied are too short. Other than that a great product.

This meter for this low price feels remarkably solid. The backlight button was a higher on the left than on the right side but works perfectly fine. Readings are repeatable and seem to be right on. I'm perfectly happy with it.Follow up: I wish the range for capacitors was a little better. For me 200uF is not great. the inductor range on the low side is also not always sufficient. A commonly used 4k7 (4.7uH) measures as 0.000 mH should have read 0.004 or 0.005

I found several out of spec capacitors in a function generator and now it calibrates as advertised. Hooray!

Okay for an inexpensive meter. For inductance, there is an offset of -10uh. No big deal; I can add 10 to the reading. Haven’t checked capacitance.