Edge Banding Trimmer,Tungsten Carbide Blades,Manual Woodworking Tool,Red | Hand Planer for Trimming ABS, PVC, Veneer and Melamine Wood Edge Banding

This trimmer has worked really well for us. It does a great job and is very easy to use. We have used this tool several times and it stays sharp and cuts smoothly.

It works really good, first time applying edge banding and removing the excess with this tool was a breeze

Work great just let the banding cool down before you cut it . A lesson I learned the hard way .

Practico corta cantos,antes lo hacía a mano por cada lado pero con este me ahorro ese paso.

Does it’s job!

Works great for 19mm ply but not 12mm. Doesn't close enough to trim 1/2 inch ply.

Have used this trimmer about 10 times and it does a good job of trimming away excess edge banding. Used it on quite a few shelves for some cabinets and they all turned out nice. Light pressure is all you need, a lesson I learned from squeezing too hard and not getting the results I wanted. In my opinion the trimmers price, performance and ease of use make it a must buy for your edge banding needs.

I made a shelf out of cabinet grade ply and put edge banding to hide the plies. This tool worked... mostly. On long straight sections this is much easier than using a razor however, because the cutter is in the middle, if you come to a joint (ex. 90 degree) you can't go all the way up to the corner because the blade sits an inch or so back from the end of the tool. You can finish that last bit with a razor but in my case, the shelves weren't that far apart so it was easier just to do it all by hand. This also doesn't work well on round parts, obviously the tool is flat but I figured with the blade in the middle it would work but, it can cause tear-out because the blade somewhat pulls on the edge banding as it's rounding a corner. All in all, if you're just doing straight boards then this tool works great, do watch your hands because the trimmed veneer will hurt as it comes out of the tool. In hindsight maybe it would be better to try and edge band before putting the project together but that seems like more work than just trimming edge banding by hand. I probably won't be using this tool much.

Just what is needed