Rev-A-Shelf - 6572-11-11-52 - 11 in. White Polymer Tip Out Sink Front Trays and Hinges

Happy using it.

Exactly fits in place of broken original

Works great, would definitely recommend to others looking to maximize their storage. They do close a little hard. All in all I did 8 of these and I’ll list the process I found worked best. I would highly advise installing these before sinks are set and if you can do it before countertops even better but if your past that point it’s not too late just need more time and elbow grease. Tips for install: 1) Use the template or rise the hinges up equally on both sides. If you set the hinges flush with drawer opening it will be too low and you’ll have a gap at the top of the drawer 2) pre drill all your holes and set screws before final install. Pre drilling all your holes and setting the screws before your final install will save you the frustration of trying to work it under a cabinet and next to a sink base. Here’s the way I found easiest to install this product 1. set hinges by using the template and pre drilling the holes, use one of the screws and set in your pre drill then unscrew it. This will ensure the screw will go in smoothly when actually installing it. Just be sure not to over torque or repeat this too many times as it could damage you cabinet and you’ll have to find a bigger screw or a new hole. 2. mark where on the door where the hinge holes meet, you can do this by using masking/painters tape and holding the door in place and marking it from inside the cabinet (you can do it this way or if you want to spend more time doing the math and measurements that’ll work too I just found that takes more time) 3. Once you have the marks for the hinges on your door you can pre drilling and use the same method as step one just be careful not to drill through the door. 4. setting the bucket/tub for the drawer, ultimately it will depend on how your doors are. I found going about 1/8in from the top of the drawer worked best for me as if your too close to the top the bucket will get caught on the drawer slot. Once you’ve got the bucket/tub where you got it mark, pre drill, and this time leave the screws in as they shouldn’t be in the way of anything. I left my screws snug enough to the bucket that it won’t rattle when closing but lose enough to be able to pull it in and out for cleaning. 5. Once you have your bucket set you can take the bucket out. Move the hinges to the open position and if you can thread the first few screws by hand. Once you do that you can use a ratchet with a 1/4 socket or a 90° screw gun/screw driver to snug the screws up. 6. Finally set your buckets in and clean up. The first one took me about 45 minutes and by the 8th I had it down to about a 20-30 minute install.

It was perfect, installation was quick and easy. Shelves are sturdy with ample storage space. Hinges are of good quality. I would recommend this product.

I bought these for my Ilan, sink renovation. They worked as described, however not as easy to install as you would think. Since my sink is installed already it’s a little difficult because of the limited space you have. It took me about five hours of work to install them and have them work properly.. once I was done they worked very nicely.

Nice concept but I had to return it since it does not work with the types of faux drawers I have.