humancentric Vesa Mount Adapter For Dell S2218, Se2219, S2318, S2319, S2418, S2419, Se2419, S2718, S2719, Se2719 Monitors | Does Not Fit Ultrathin Monitors S2718D, S2719Hm, S2719Dm, Black

Very good, you can trust it.

I ordered it from India and the product was shipped from US. Off course it took a while for the product to delivered - the packaging was very sturdy. The product itself is perfect. Does what it says. I feel that I could have found the same adapter from a local IT market at a cheaper rate but probably the build quality might not be so good.

This was easy to install and worked well with the desk mounted computer arm I have. Nice and tight, the monitor is secure.

Turned a non VESA monitor a VESA monitor and my setup is looking slick!

Cumple perfecto y da mucha seguridad una vez instalado.

This worked great! I have a Dell S2719DM monitor. It has two little screws holding the current stand to the monitor (see attached photo). I was afraid the adapter wouldn't be strong enough to turn the monitor vertically on its side (portrait aspect ratio), but it was perfectly strong and without any give, bending, or shaking. The only part that was tough was pressing down the adapter on the back of the monitor to get the two screw holes in the adapter to line up with the screw holes of the stand joint on the back of the monitor. I was afraid of pushing down too hard and breaking the screen. But that didn't happen. It would be easier if you removed the rubber strips from the adapter that protect the back of the monitor from being scratched by the bracket. Pressing down is really only making up for that thickness. You could add soft velcro strips or two strips of duct tape between where the adapter edges touch the monitor. They MAY avoid scratches and then you'd just need GooGone to remove the stickiness. But I was ok pressing down to line up the holes. The adapter comes with four VESA screws that seem small, but they worked very well for my control arms and lines up easily. They are only slightly bigger than the monitor stand screws, so they are quite capable of supporting the monitor weight. You will still need the two screws that came with the monitor stand to connect the adapter to the monitor. That's also great because then you don't lose them if you plan to sell the monitor later with it's original stand. I am very thankful someone created this adapter! I was able to get a great looking monitor and use it in a way Dell didn't plan for us ergonomic correct users. :) Really happy with this!

It does what it promises, and gives a second life to a monitor that had no vesa mount. I would like a better mechanism to stabilize the monitor instead of a srew but I can realize that it was not so easy.