Rail Mount Heavy Duty Bike Hoist and Ladder Lift - Quality Bicycle Hoist

Holds my 25kg GasGas Ebike without a problem. Seems well built, would buy again.

El producto es bastante bueno para su precio. Las poleas son un poco chicas y la cuerda tiende a salirse mucho de ellas. Es facil armarlo pero no instalarlo. Los tornillos con los que viene no son tan de buena calidad (3 se me doblaron y uno se le rompio la cabeza). Tampoco trae taquetes. No trajo instructivo pero se puede encontrar el pdf si lees las reseñas en inglés. Fuera de eso. Es un excelente producto. Se monta muy faciles los ganchos y no se ve de mala calidad ningun componente. El servicio de entrega llego mas rápido de lo esperado. En general cumple con su cometido y su precio es ideal.

I bought two of these to hang up our bikes in the garage because I liked the idea of being able to lower them down with a pulley. The installation of the first one took about 45 minutes but the second one only took15 once I knew what to do. The locking mechanism works great and the quality seems decent. The only issue I had were the screws. I broke 4 screws drilling them in to the 2x4 at which point I used my own. A few tips on the install as the directions are pretty bare: 1. Use your own screws, don't use the ones that come with the equipment. 2. Decide where you want the bike to settle to the ground first then center the bracket above it on the ceiling. 3. You should place the back tire on the side where the latch is so the handle bar is not in the way. 4. To life and lower the bike, you should stand in the middle of the bike (by the seat) and pull the rope towards the middle of the bike. This will release the latch and allow for smooth raising and lowering. The last piece of advice is how to put the cord through the latch. I had to youtube a video to see how but the rope goes through the hold and under the lever that lifts. The rest is easy. Good luck and enjoy, this was a nice buy.

Beim dritten Mal benutzen um das E-bicke zu reinigen ist der Aufnahme Haken abgebrochen. Aluguss erweist sich als nicht geeignet.

This bike lift was easy to install and works well even on an electric bike