Stainless Steel Ethernet Wall Plate with Single RJ45 Waterproof CAT6 Jack - Outdoor IP68 Ethernet Wall Outlet for Secure PoE and Data Connection

Did exactly what I needed and looks great!

Close but no cigar ....... This looked like a great product but connections would not carry a signal thru the RJ45 connections. I had to modify to be able to use. The encasement is not large enough to to contain the connector and strain relief boots necessary to compress the rubber to affect water proofing.

Works as intended as long as you are doing your own bootless crimp terminals on the end of your cable runs. You will have to cut the rubber boot off your cables if you are using premade lines. Same with any cables you intend to plug into the port. The watertight sleeve won’t work if cable has the rubber boot on it.

Not the one to get. It does technically work, but... the quality is low, the way the jacks are angled, you can barely fit the cables in. The screws don't fit an outlet box so they're no good unless you want to force them to fit into the plastic thing, they give you which I couldn't imagine someone using on the exterior of their house and probably the flanges wouldn't reach if you did want to do that and cut a giant hole in the side of your house. The stainless steel is thin and the plate is barely big enough to cover an outlet box and the foam is too small to make a watertight seal against anything it just sits in the recess and isn't nearly big enough to reach an outlet box edge, so I got a blink plate and use the screw and foam from it. This is already pricey for what it is, you're probably better off just getting an outdoor outlet cover and an outlet keystone plate.

Did not work for poe cam

Several different newly manufactured ethernet cables with RJ45 connectors could not fit into the jack locations.