100GPD 6-Stage Reverse Osmosis RO DI (De-ionisation) Water Filter - RODI10D

Ok, this is a review based on early use. I had the unit installed under the sink and the filters flushed in about 45 min. The installation was smooth as could be. Zero leaks. And they even send a couple extra common parts and a extra set of O rings for the canister filters. The manual could not of been done better. Concise and in wording. ( i am a maintenance tech and see manuals that are so bad you can not sense of them and get a headache trying to. So I had the filters flushed and filled the tank for the inital fill. From opening the box ( beautifully packaged btw! ) to drawing my first glass of water ( after 4 tank flushes ) took appx 7 hrs, and the water taste better than my old trusty zerowater. Not only do i have pure drinking water I have pure water to run in my humidifiers that WILL NOT leave white mineral powder behind Quality of the unit 10 of 10 Manual and ease of setup/install flawless Ease of use and taste of filtered water perfect. I would recommend and would buy again. As a bonus the filters are very easy to replace when the time comes

Muy buen producto... Los materiales son de muy buena calidad... la instalación fue muy sencilla... Llevo con el 2 semanas y no me ha dado ningun problema... No creo que lo haga.... Lo recomiendo ampliamente.

I had been wanting a RO/DI ststem for a while. I keep aquariums and plants that require very pure water. The water from out of the tap is over 400μS. This system took it down to between 5-7. If you have very hard water like I do you may want to get a whole house filter as well for pre treatment(this will be my next project) , but this does do a great job of cleaning the water without one. The installation on a stainless kitchen sink took about an hour. Hardest part was drilling a hole in the steel for faucet, and that took about two minutes with a step drill or knockout punch. The system is pre assembled all you have to do besides installing the faucet is drill a hole in the waste water pipe and match up the tubes to the right color. If you want you can save the wate water for other purposes and skip installing the waste water saddle. Water tastes great as well. There are different upgrades you can purchase separately as well. I do wish they had a 200gpd RO membrane that is the only fault I have found so far. Had it installed for about a month. The fact this is reverse osmosis and deionized at the price point cannot be beat.

flujo-presion de agua de salida, es muy pobre

I have had this installed for just over 60 days now and run on average 5-10gallons of water per day through it. I am very happy, water incoming is 250-300ppm tds, out was zero for quite a while, today reading only 3 ppm still. Even just averaging 7 gal per day for 60 days that means this unit has given me over 420 gallons of purified water already. I was paying 50 cents per gallon to refill 5 gallon bottles before. So this unit is quickly reaching ROI and will do so well before filter replacement is required. The convenience is also not being factored. There is much value in not carrying 5 gallon jugs around to refill at the store, my back is very happy with the change. I have done filter jugs like brita and zero, they never ROI, make much trash, and aren’t very convenient. This unit I had installed in 2-3 hours. It’s easy but requires attention to detail and a little pride in your work to do a good job. You could probably do it faster but take your time and so it well. Don’t trust any of the factory connections out of the box, they will leak. Undo them all and reseat them all yourself. If you do this you should be fine. Expect leaks the first time you open up the system so be prepared to stop the source and soak up water. The water this provides is excellent. For the cost and convenience I am very happy to have this system.