KC 6300 Universal Wire Hider (3 Feet)

Installed an over-cab light bar and needed some way to hide the power cable that runs down the windshield. This was exactly as described and provided the perfect solution. Adhesive was strong and has held up to weather, the rubber part fit a half inch cable well and keeps it hidden. I’ve recommended it to several friends and co-workers.

Bought this to hide my KC Titan wiring harness and works great, almost thought I ruined it when I was at the car wash with the power sprayer and was cleaning the windshield when I noticed that I was spraying right into the underside of the wire hider but it never came up off the windshield, so would not recommend doing that to often but it held up great and would buy it again.

It hides my wires as described. It secures fits along the edge of the windshield and blends it in nicely to look OEM. It comes with 3M adhesive strips and seems to hold so far. Install was a breeze, Instructions were sufficient.

Good product make running wires on the outside of your vehicle easy and clean looking

This is the easiest and best way (in my opinion) to hide wires going up to your roof rack or light bar. I am using this wire hider to run wires up to my roof rack for camp lights. Install was super easy. I simply measured and cut the wire hider using scissors pretty close to the size I needed. Then I lined it up on my windshield and trimmed it to the perfect size I wanted. I prepped the glass by cleaning it with the provided alcohol wipes, applied the 3m tape to the wire hider and then stuck it onto the windshield. After it’s mounted you can easily insert wires and also remove them as needed. I’ve had the wire hider on my vehicle for about 4 months now and I have no complaints. It blends in very well and most people don’t even notice it on the windshield until I point it out.

Used this to hide the wires for a dash cam in a Wrangler. The three foot length of the hider is perfect for my application. The only downside I faced was the adhesive channel is as shallow as the tape is thick so that i double-stacked the 3M adhesive tape (after a pre-treatment with 3M 4298UV Adhesion Promoter - Tape Primer). I removed the passenger's side sun visor mounting bracket to run the wire hider along the windshield frame, then replaced it before the primer had set, cinching the wire hider even more snugly in place in the upper corner. The wire hider is exactly what I wanted to secure the wires from the dash cam.

Used this to the wires for lights on my roof. Take your time prepping and installing and it'll come out looking great. I peeled and attached one section of tape at a time so that I could get it lined up perfectly. It looks professional and keeps wires hidden and out of the way. Water drains off of it just fine

This is a great option for managing wires for offroad lights. Blends in and looks good on my Jeep renegade. Universal fit makes it easy to cut to a customer fit length.This would be 5 stars if it weren't for the crappy double sided tape that's included.I made sure to clean and prep both the surfaces (Windshield glass and the hider). Once installed left it sit overnight to cure. Ran wires the next day. Within a week it was peeling away in a couple spots. Spot patched with leftover tape. In 9 months I've had to redo it 3 times.Now I have to go buy some new tape, hopefully better than what was provided.Buyer beware, and buy you some extra tape with more bonding strength.