WSOOX 1/4 Inch Shank 45 Degree Lock Mitre Joint Router Bit

Very good tool very good price for a d i y. Just done test runs so onto finish item

Right size. Sharp enough good value

Not good on plywood

Sent them back largest cutter was damaged. One cutter face was chipped and parts of the trailing edge were bent

They work great.

Great quality, they work great.

Got quick. look like good quality

Evidently, these are too finicky for hand routers. Just too difficult to align router and stock for a good cut. While this was not claimed in description, and I am a beginner - it might have been obvious to a more experienced person. Second, my 1 3/8 and 1 1/2 bits were both 1 3/8 in diameter. The 1 1/2 bit *was* taller. It would be helpful if the bit description (on the container) clearly stated expected stock thickness, not just the bit size. Especially as the 1 3/8 is evidently for 1/2 stock, and the 1 1/2 bit is for 5/8 stock (I think)! Also, as I could not get it to work on my hand router (so no proof), but the bottom edge of all three bits were not symmetrical - one “tooth” stuck out noticeably lower. From YT videos on setup, this might not matter as all of them had the lower part of the bit below the bottom of the table, but it does seem odd. I am NOT saying these don’t work. I’ll keep them for when I have a table, where the videos show it’s easy if setup correctly.

Arrived very sharp and after cutting a few feet of hardwood still held its edge