DipYourCar DYC Wheel Kit - Matte Black

Muy buen producto llego muy bien empacado y en buen tiempo

not bad for the price even tho its cheaper at some local stores..even tho its a wheel kit, but i only needed 2 and half cans, could have done the job with only 2 cans had it not been for the wheels being so bad..had to scrape and sand the inside walls of the wheels and wash the whole thing then applied one heavy coat, one coat would be more than enough if you have the wheel laid down and you spraying it downward that was you can get wetter heavier coat to get full coverage all together with one coat.. i bought a set of black lug nuts so its easier than painting the old ones and no peeling while tightening them on..the paint dries to the touch in 15 minutes or less [it was 78 degree outside ]and can put the wheel back on in less than an hour with care..this paint is not retouch friendly, so its better to peel it off and respray instead of trying to retouch defected areas..it is a very easy to use product all you need is common sense ...i uploaded the before and after pics, and yes that was just one coat of paint.. i chose not to retouch the areas where it peeled off while taking the tape off.. but all in all , its not bad for a DIY for less than 35 dollars..

This worked extremely well and if you have time and dedication can look professional. I used all four cans. Best method I found was to remove wheels and line the edge of the rim and tire with playing cards to make a barrier to prevent from over spray. Make sure the wheels are very clean first. Then using small quick sprays, not long continuous go over the whole wheel a little bit at a time. I found doing a lot made it look very bumpy and runny. It took numerous coats to get the whole wheel covered and different angles but looks great. Between coats it was important to let it dry. To speed the drying process I used a hot air gun. Its been 3 months now and still looks fresh and like it was just done. Do not drive until its very dry (at least 4 hrs) or it will make it spiral outward or spray off the wheel.

I only needed 2 cans to do 5 wheels for a 2010 Jeep Wrangler. As everyone has said, prep is the key and light coats. I searched You Tube and found some great tutorials. My advice is light coats and lots of them to avoid runs. I used playing cards as suggested to protect against over spray. My garage smells like paint fumes, but the results are great. It took most of the day as I sprayed light coats, waited 20 minutes between the coats and then let sit overnight. I also heated the cans in hot water as it is cold here right now.I am happy to have the extra cans for touch ups.

This product is basically spray rubber, which makes it a cool and unique product. It comes out as a very light spray which allows you to use several coats to get complete coverage on whatever you are spraying.