Customadeonly 2pcs 5mm Hubcentric Wheel Spacers 5x108 | 63.4mm Hub | Silver | to Widen Stance, Offset Correction & Appearance Enhancing | for Ford Fusion, Jaguar F-Type

Great quality, fit perfectly on my focus st. Would definitely buy again

Good quality

Fits on 2017 Focus st. Video shows on why I needed it lol.

Picture 1: 25mm Spacers Picture 2: For 20mm Spacer. All have same threads - Center from Advance, Left 20@$10 too large. Right came with 20mm Spacers so don't feel safe. Volvo OE Nuts are longer than the large left wheel nut. The nuts shown are for attaching spacer to hub. Picture 3: 25mm Spacers On 08C30T5 2.0 18" Rims Ford had its hands in Volvo, Jag and Mazda for quite sometime so many parts were the same in the suspension department. These 25mm spacers should work for all years of the Volvo C30 rear wheels. Was hoping to use the 20mm Spacers but the nuts provided are somewhat short compared with Volvo's where it attaches to the hub's studs. Tried various lug nuts where it attaches to the hub's studs and most will be too tall so the rims will not be flat against the spacer. Not only will this cause vibration making the car undriveable but it could potentially cause the studs to break and the wheel coming off. The only nut that will work can be found at Advance Auto at a cost of almost $2.50 each X 20. Too expensive at that point. The 20mm was $20 more so settled for this 25mm or 1" spacers. During installation be sure to use a wire brush to remove as EVENLY as possible all rust / oxidation from the brake rotor front plate and wheels hub bore besides the back of the rim. This will allow a smooth and flat installation eliminating any shimmy or vibration as the speed increases. Lastly use a 300 to 400 grit sand paper on the back of the 25mm spacer to smooth out any nicks or bumps caused from shipping or mishandling. Put the sand paper down on a flat surface and lay the back of the spacer on top and gently do a small figure 8 and look in the back for any noticeable darkness from bumps or nicks. Spray the entire front and back of the spacer missing, not the stud / bolts with silicone spray and wipe down. Do this for the back of the rim and hub on the car but making sure to miss the brake rotor and pads. Cover it if need be.

Good product. There was a serious problem with what was sent to me (received adapters instead of the simple spacers that were described) but was able to get in direct contact with manufacturer who quickly confirmed the problem and resolved it my satisfaction. Great customer service. And the product that I received was of good quality. Thank you

Very good quality but unfortunately I had to return them because I didn't have enough of the wheel stud left to safely mount the wheel

Middle bore wasn’t big enough to fit my 94 Volvo it was returned.

Honestly, it was a little scary to buy car parts from Amazon.. but these are SOLID. I’ve had them on for about a month or so? Maybe a little longer. They’re REALLY well made. I drive a lifted Ford Focus RS 2017, and needed some clearance from my new shocks. These have been working great. If anyone with a 5x4.25 bolt pattern is on the fence about these - go for it. They’re high quality.

Super soft . Theads weren't the same all the way around. Easy to break

Great Feature ,Thanks

Thank Martin