Loctite Power Grab Ultimate Construction Adhesive, ultimate strength adhesive, 0 second instant grab, high tack adhesive, No-nails and screws, no clamping, no mixing, metal, tiles, wood, concrete 440g

This stuff is the bomb! I searched all over for a product that could be used to bond fiber reinforced panels to a welded steel garage door frame. This worked great under tough conditions. I can't speak to the normal time to set but, even in proper temperature conditions, I think this material will require clamping to hold on vertical surface.. I did not use it in anywhere near optimum (or even recommended) conditions. I used this on the frames of an exterior garage swing door and did so last April in record cold. Nights were in the high 20s Fahrenheit. Daytime highs of no more than 55. I could not close the doors due to the clamps. I do not recommend this application environment and doubt the manufacturer would either. However, this stuff dried to a tough, slightly pliable bond within 24-36 hours. Again, no idea of set time in proper conditions. I also applied the FRP to older steel with a significant patina of rust. I did use an angle grinder to remove a couple of sections of heavier scale, but that's it. This stuff grabbed tight. I got about 90 feet of medium bead per tube and used the excess for a variety of other applications including bonding plastic (polyethylene) and veneer to plywood. Great stuff!

I sticked a huge 3ft x 4ft cabinet on my bathroom wall with this construction adhesive without any nails and it did the job. The cabinet was heavy. And its hanging strongly. 5Star

We used it for styrofoam ceiling panels. It worked excellent. A little thick to pump out t worded

Tube needs to be put in HOT water for about 30 minutes before it will flow out of tube.

The polymer binds very well, as claimed. However, without a plunger, very difficult to get the polymer out and leads to wastage and breakages