• ing Hole (30X30) LiPo Power input: 3S-6S Cont.Current: 60Ax4 Burst Current: 80Ax4 BEC Output: 5V@ 0.5A High-performance 32-bit microprocessor with the running frequency of up to 48MHz for an excellent performance. Input wires: 12AWG-130mm* (Red/Black) Output Wire: No wires but solder tabs.

Safety Protocols: Read through the manuals of all power devices and aircraft and ensure the power configuration is rational before using this unit, as improper power configuration will overload the motor and damage the unit. When installing this unit, relevant operations like soldering, connecting will be needed, so please ensure all wires and connections are well insulated before connecting the unit to related devices, as short circuit will damage the unit. When soldering relevant wires of the unit, please use a soldering iron with sufficient power to do the job, as poor connection may cause your aircraft to lose control or other unpredictable issues like damage to the device. Always keep your aircraft away from unsafe elements like obstacles, crowd, high-voltage power lines. Please fly your aircraft in the working environment as regulated in this manual. Although there are some protections, improper use may still cause permanent damage to the product. Always disconnect and remove batteries after use, as the ESC may drive the motor to rotate and cause unpredictable danger if it`s still connected to the battery. Long-time contact will cause the battery to completely discharge and result in damage to the battery or/and the ESC. High-performance 32-bit microprocessor with the running frequency of up to 48MHz for an excellent performance. BLHeli_32 firmware is the third generation BLHeli, following base BLHeli and BLHeli-S. All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling. The code supports features to prevent sync loss. There are tunable parameters that can make the code run well even in the most demanding situations, although default settings will work excellently in normal operating environments. The code supports regular 1-2ms pulse width input, as well as One125 (125-250us), One42 (41.7-83.3us) and Multi (5-25us).