3D Printer Water-Washable Rapid Resin, Model Gray 405nm LCD UV-Curing Photopolymer Resin for High Precision Printing, Low Odor, Non-Brittle, Easy to Print, Easy to Clean and Cure (1KG)

Really great resin. Almost no bad smells. Very easy to clean prints, just use water, no ipa needed! Just a huge price jump recently, ☹️

Will keep ordering this resin so easy to wash and with water muhaa way cheaper then alcohol. Printed on my sonic mini 4k . Will order more soon

This resin has been great so far for printing miniatures in my anycubic photon mono. It shows detail fantastically. The cured models have some flex to them which should make them less prone to breaking. Ran the anycubic resin calibration print and ended up with 2.6 second exposure times per layer. That's for a mono screen. It's water washability is.. OK... In an anycubic wash and cure 2.0 I wash it in water for about 15 minutes. That removes the majority of the resin but there's generally still some in the crevices of the print. A couple sprays with some IPA is enough to get the last bit. I find a cure time of 4-6 minutes in the curing station cures it enough to harden the model but still leaves some flex.

Best Resin I got so far, very low odor, some flex but rigid

Using this in an Anycubic Photon Mono 2. This stuff is amazing. As usual, once you zero in your exposure and such, mis-prints are a non issue. My exposure is set at 2.80 and I have no problems. The smell is very minimal and clean up is a snap since its water washable. And with a rinse and cure machine it's a no brainer. 5 minute cure time and the minis are just the right flexibility for normal gaming use. Do yourself a favor. If your are in the market for a water washable resin for your 3d printer for gaming minis, search no more. This is the stuff.

Great train at great price point. I was using this specifically to print dental models and once I figured out the specs that were good for that purpose, it was pretty smooth sailing. It doesn't cause a strong odor and I found it pretty forgiving as far as cleanups go. Do make sure you have the adequate temps around printer and resin though because it definitely makes a difference!