Taylor Precision 5329 Indoor/Outdoor Thermometer/Hygrometer, 10 to 80% humidity range, -40° to 120°F (-40° to 40° C) temperature range, extend tubing out window to read outdoor temperature from inside

I replaced an identical unit when the outdoor sensor was painted over during a paint job. Even after the paint was removed the outdoor temperature reading was no longer accurate. This new unit was very easy to install and the readings are accurate. Previous unit (same brand and model) worked for decades, so expect same for this one. Sensor wire required elaborate bending to accommodate sliding window, as with the original, which did not affect its accuracy. Unit gives you interior humidity, exterior/internal temperature in an easy to read setup. Recommend it.

Piece of junk, This was purchased to replace an almost exactly similar model Taylor thermometer I bought 25 yr ago. The difference in quality is apalling. The indoor part can't be easily read in normal room light. You would think the red would jump right out at you but you have to move your head back & forth to see it & it's hard to see at that. If you shine a light on it, it can be seen OK (not as well as the old one) but I can't carry a flashlight with me just to read this. The instructions say to mount it out of direct light so sunlight will not influence the temperature display...so it's on the north side (dark side) of the room. I could see the old one fine. The outdoor part didn't display the right temperature...it was reading 9 degrees (F) high. I had to take it apart, cut the glue holding the glass tube & move it down to show the correct temperature, then re-glue it. The humidity gauge may show the right reading at some point but if you tap it lightly, the display swings 20-40 percentage points. While I was trying to adjust it, the back popped off & I had to reglue that, too because that's where the mounting holes are. There has to be something better.

my husband loves it, better than the other one he had..

Built rather flimsy. Make the plastic thicker. And put a dial needle on barometer. Works ok though, seems accurate compared to other thermometers. Outside temp is right

This thermometer has the degrees in both C & F. Works great for checking the temperature outside.

After following the directions on the box regarding the liquid getting stuck at the top during transit, some of the blue liquid did fall back down. However, after removing it from the box and letting it sit for days, inside, the temperatures were never the same, despite the sensor being right next to the thermometer in the same room. It’s not useful to me to if the temperatures are not accurate. And it’s not returnable.

Had one of these for years, it finally went kaput so got this replacement. This one has a hygrometer, which seems to read high (never below 75, but that may be true) but the thermometers seemed to be very accurate, until the weather got cold. Yesterday it was accurate at 75 inside, 68 outside. Today it is cold outside, another thermometer (Weston industrial dial type) reads 55 degrees inside (a shed) but the Taylor says 52. On an earlier cold day it was much colder in the shed but this Taylor seemed stuck at about 50 degrees. Today the Springfield 12" bulb-type on the porch says 33, a digital type with remote on the other end of the house says 34.5, but the Taylor says 30. Nothing is frozen so it's the wrong one. The need for accuracy is most important near freezing, most anything else is just a matter of idle interest, plus or minus 3 degrees.

Very happy

Did not work ? Outside thermometer does not move and it is set up correctly want to return ??? Followed directions to equalize tubes but did not help