3.5 inch 60W 2 Way Coaxial Car Speaker | Great Stock Replacement, Balanced Sound + Smooth Treble, Easy Installation

Took me about 15 minutes to install one speaker, learning each step as I went. Second speaker took about 5 minutes. Sound quality is marginally better, but the sound stage is vastly improved. Sound is pointed at you instead of bouncing off glass and dash. Appearance is good. Pretty close match to the dash color and texture, but not perfect. All in all, worth it to make a quick and easy improvement to the sound of the factory system.

元々音質にはそんなに不満はなかったのですが、 さらに良くなればということで購入。 配線は少し加工が必要でしたがあとはポン付けでOKでした(°∀°) ツイーターも一緒に変えたのもありますが更に音質が良くなって満足です！(°∀°) ドアパネルのスピーカーも変えようと思いましたが、 しばらくはこの音で楽しみたいと思います('∀` )

I've long since upgrade the sound system on my 2006 PT Cruiser. Did a 6x9 conversion all round, have 2 amps and a sub. Never got around to doing the tweeters. But I soon tired of the horrific high pitch from the stock pieces of junk when the volume was cranked. No surprise when I examined my tweeters how poor of a condition they were in. I gently touched the cone, and it cracked like old paint. Not good. I pulled the stock ones, and used a 9v battery to determine the positive and negative poles on the stock wire connector. (You can use a 9v square battery on the contacts of a speaker to determine polarity - If the cone pushes out, you have the correct orientation. If it goes down, flip your polarity). Once I had this figured out, I wired in an additional capacitor. My amp pushes out a good deal of power, and without reducing the bass it would tear these to pieces. I will link what I used below. Once wiring and fitting was complete, I had to adjust my Equalizer due to the change in frequency at the front end. But once I dialled it in, it sounds amazing. Significantly better than the awful sound quality from before. And it's a little louder, and these will be more durable long term. I did not have to trim or cut up my dash, they just fitted. I got rid of the star screws my dash came with, and used the supplied cross screws from this kit to make things easier. If you're considering replacing your dash speakers, you should buy these. If you are replacing dash TWEETERS, you WILL NEED a capacitor or you will trash your speakers. Here is the cap I used: https://www.amazon.com/gp/product/B00H3RL6NI/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1

No trimming, good fit in the headrests of a 1990 Miata. Miles above the factory paper speakers. Not much in the realm for base, but the high's and mid's make the sound from the only two door speakers come alive. Can hear them very well with the top down, still clear. Easy to install.